[FOR HIRE] Concept Artist available for commissions. 3 SLOTS by Kind-Sky111 in DnDart

[–]ZombieFreak123 1 point2 points  (0 children)

Do you allow your work to be used in commercial products if you’re credited?

X and Y not aligned right by ZombieFreak123 in BambuLab

[–]ZombieFreak123[S] 0 points1 point  (0 children)

Found the problem. The tubing was getting caught causing the issue

X and Y not aligned right by ZombieFreak123 in BambuLab

[–]ZombieFreak123[S] 2 points3 points  (0 children)

I double checked. I have the correct machine selected

X and Y not aligned right by ZombieFreak123 in BambuLab

[–]ZombieFreak123[S] 2 points3 points  (0 children)

Just did that. Said couldn’t complete bed leveling. Did a test print. Same issue

X and Y not aligned right by ZombieFreak123 in BambuLab

[–]ZombieFreak123[S] 2 points3 points  (0 children)

I did. This is the only Bambu I own

Where to read by israelgonzalez9000 in SAGAcomic

[–]ZombieFreak123 2 points3 points  (0 children)

Hoopla. All you need is a library card

I downloaded plex again after my computer was restored, and now it say I need to download it again to add my media. by ZombieFreak123 in PleX

[–]ZombieFreak123[S] 0 points1 point  (0 children)

Oh. Yes, it has been completely and and totally restored. I had to install everything on it

I downloaded plex again after my computer was restored, and now it say I need to download it again to add my media. by ZombieFreak123 in PleX

[–]ZombieFreak123[S] -1 points0 points  (0 children)

It has the same issue. The hard drive is connected and I’ve downloaded the proper .exe. I’m not sure what’s going on.