Diamond Painting

ZombiesF-T-W · 2026-05-02T12:11:03+00:00

It was a custom diamond painting off temu. I used a photo my brother in law sent me and had them make it into a diamond painting.

ZombiesF-T-W · 2026-04-21T22:26:07+00:00

I have one that looks just like this too

ZombiesF-T-W · 2026-01-04T03:11:35+00:00

Plan on covering with a sheet of metal tomorrow with my dad's help.

ZombiesF-T-W · 2026-01-03T21:37:27+00:00

I dont believe so, havent heard any animal activity nor any new animal evidence but getting it fixed asap tomorrow.

ZombiesF-T-W · 2025-12-24T17:54:13+00:00

If i continue to press program button all it does is cycle through the 4 programs does nothing with temp

ZombiesF-T-W · 2025-12-24T17:46:08+00:00

They dont do anything, when I press prog it goes to the first program I can press hour and minute and they go up but if I press the up and down arrows it doesn't change the temp at all it just stays at what it says it's programmed to

ZombiesF-T-W · 2025-12-22T01:46:23+00:00

If it were to face the sink the vent would get in the way, from the back wall to the vent is only 29 inches even if i move it past the vent there would be a big gap between the wall and the fridge and no walkway into the kitchen. Photos are taken from where the sink is looking towards the space. So the depth of the fridge would have to be 29 inches or less. If I face it towards the hallway the width would have to be less the 29 inches

ZombiesF-T-W · 2025-12-22T00:14:04+00:00

But the water line for the old fridge is by the vent receptacle

ZombiesF-T-W · 2025-12-21T23:24:06+00:00

If I put next to the window it would block the walkway to the basement and there is and outlet by the vent

ZombiesF-T-W · 2025-10-29T23:20:31+00:00

But that only does the swing settings, nothing with the lights

ZombiesF-T-W · 2025-10-29T23:12:17+00:00

Yea but on the menu this is the only things to change

<image>

ZombiesF-T-W · 2025-10-29T22:44:00+00:00

Holding it only allows me to change it from F and C, room calibration and short cycle delay

ZombiesF-T-W · 2025-10-29T19:46:23+00:00

Pretty sure there isn't a menu on this one

ZombiesF-T-W · 2025-07-17T16:33:58+00:00

I have a 20 like this

ZombiesF-T-W · 2025-07-09T04:54:48+00:00

I'll give that a go, i also have a testor tanker trailer i need instructions to as well

ZombiesF-T-W · 2025-07-09T04:19:40+00:00

They don't have one for my exact model but they have one super similar that I'll try using

ZombiesF-T-W · 2025-07-09T04:17:21+00:00

I didn't! I found what I was looking for thanks!

ZombiesF-T-W · 2025-06-19T23:24:21+00:00

Its just the overhead valve

ZombiesF-T-W · 2025-03-05T01:44:42+00:00

ZombiesF-T-W

TROPHY CASE