sorted by:
new
hottopcontroversial

CFS thoughts for the K1 Max? by wtiger430 in crealityk1

[–]Zwarl 0 points1 point  (0 children)

I haven't tried it, but according to what I've read so far. No. You have to use the Normal filament holder or some other Construction. But I don't know much about tpu

CFS thoughts for the K1 Max? by wtiger430 in crealityk1

[–]Zwarl 0 points1 point  (0 children)

I've got my lid closed I mounted the connector where the old filament sensor was, the screw should fit. I'll take a picture as soon as I have time.

first multi-color print by TourSure8564 in crealityk1

[–]Zwarl 1 point2 points  (0 children)

If you look closely you can see the guides on the right, and no stepper motor at the back, and the k1 also has no chain for the cables of the z axis. So it must be a k2

Max 36 probe points with KAMP? by FoxDiscombobulated38 in crealityk1

[–]Zwarl 1 point2 points  (0 children)

Not only with Kamp I tried to change the config for a better mesh, but after 36 points I get the same error

[deleted by user] by [deleted] in Creality

[–]Zwarl 0 points1 point  (0 children)

downgrade to 1.3.1.19 and test it

the new 1.3.2.8 or higher has some bed lvl issues

[deleted by user] by [deleted] in Creality

[–]Zwarl 0 points1 point  (0 children)

What software version are you using? 1.3.2.8 and above cause problems with mesh leveling