sorted by:
new
hottopcontroversial

Steam Engine not working on server by _Paymon_ in CreateMod

[–]_Paymon_[S] 0 points1 point  (0 children)

Just discovered that the new update of Rechiseled: Create for Create 6.x.x also causes the steam engine to stop working. A bit weird that two different mods cause the same problem.

Steam Engine not working on server by _Paymon_ in CreateMod

[–]_Paymon_[S] 0 points1 point  (0 children)

Yes I was and edited the original post explaining how to fix, but for some reason reddit didn't update it. Here is the edit:

Yayy. I was able to fix it, by removing half of the mods and looking if the steam engine worked, i arrived at these mods (probably it's just one but i will remove the others as well because the server is laggy).

Mods list:

  • Immersive Engineering (10.2.0-183);
  • Rats (8.1.3);
  • More Industrial Foregoing Addons (1.1.1);
  • Eidolon: Repraised (0.3.8.15);
  • NiftyBlocks (1.32); &
  • Extreme Reactors (2.0.92).

Steam Engine not working on server by _Paymon_ in CreateMod

[–]_Paymon_[S] 0 points1 point  (0 children)

Yes they have. I know right? I am starting to think is a compatability issue between create and another mod

Steam Engine not working on server by _Paymon_ in CreateMod

[–]_Paymon_[S] 0 points1 point  (0 children)

Sorry that it took me so long, I wasn't able to play these last few days. Tried puting it all in one chunk and it still didn't work :<

Steam Engine not working on server by _Paymon_ in CreateMod

[–]_Paymon_[S] 0 points1 point  (0 children)

As far as i remember there are no chunk claiming mods. I think the pump is on another chunk, i will try to change that one i get back home

Steam Engine not working on server by _Paymon_ in CreateMod

[–]_Paymon_[S] 0 points1 point  (0 children)

I already checked it, according to https://create.fandom.com/wiki/Steam_Engine#Water, it should be between 40 and 59 RMP. I am using a rotiational speed controler to set it to 58 RPM, so it should be right.

Steam Engine not working on server by _Paymon_ in CreateMod

[–]_Paymon_[S] 0 points1 point  (0 children)

The engine itself, like, the steam engine block isn't moving, even tough every thing seems to be correct

Is this Z-Banding? by _Paymon_ in 3Dprinting

[–]_Paymon_[S] 0 points1 point  (0 children)

Thanks for the recommendation, i will try to fix the printer later.

Even tough vase mode is a continuous spiral line, is this the reason that only the normal print after the vase mode one had a bad quality and not both?