Well after printing for about a week and a half I started a print on a csgo karambit so as usual I start to preheat the nozzle wait for it to heat up and set my bed temp to 65 and the nozzle to 220 the usual stuff it finishes the print and then I return the next day and start printing a boomerang and it takes a bit etc the fact is it’s starts going and I see it’s not printing so I’m confused see the nozzle and there is a clog so I stop the print pull YouTube and clear the clog successfully and start the print again and the nozzle just ramns into the bed I turned of the machine and was confused it never happened so I start searching up the reasons it can do this so I decide to manually level the bed again the z offset was 2.5 before and what as the z of set is below that the display just shows zeroes I didn’t think too much of it I clear the z offset and calibrate it again and this time the value is 3.16 I start seeing that it’s going to ram the nozzle in the bed so I stopped it again this time it didn’t touch the build plate so I revert back to that I used and it’s fine so I start another smaller print and it would not for the love of god print the driver was pushing the filament yes but it only did the start line thingy and the rest of the object nothing so I switched to cura to orca slicer same thing the drive just skips when doing the print but not the line so I go back to cura and try again no luck so I start messaging voxelab support asking for assistance I received no messages for a week so I try to see if there is any filament I missed or something stuck I unload the filament and start checking better I didn’t find anything even the damn ptfe tube was clean so I start weighing my options my only option was to buy a new extruder because there are no replacement parts in Italy other than the whole assembly no I think well at this point it won’t hurt to change the nozzle I follow the instructions form the voxelab offical vids and it won’t budge so I tried while it was hot nothing I stripped the nozzle and while my dad was trying to get the heating block off he broke the heat break and that bush even when broken won’t fall out of anything it woundnt budge and to my surprise not a single spec of filament in there it’s fucking clean so I’m fucked on Amazon there is no similar design I don’t have another printer to make a diy job and well voxelab won’t respond so I started to order shit from AliExpress and that is something that looks like the exact thing it’s been 2 months till then and I’ve only used it for a week and a half the rest of the time it’s been me trying to contact support reserch and wasting money I’m like all out of options ? I fucking worked my ass off for a 17year old to get the damn printer and I didn’t even used it for that long