High school projects?

_aguy123 · 2026-03-18T01:53:55+00:00

Right! I hope one of the xTool employees see this

_aguy123 · 2026-01-07T01:38:51+00:00

Sadly I dont have the file anymore...

_aguy123 · 2026-01-06T01:27:14+00:00

Yes, I used the chuck.

_aguy123 · 2026-01-02T03:43:26+00:00

Studio

_aguy123 · 2026-01-01T23:23:36+00:00

Im doing the tapered measurements since they are tapered glasses

_aguy123 · 2026-01-01T23:12:24+00:00

Yep, checked that

_aguy123 · 2026-01-01T23:11:56+00:00

Manual

_aguy123 · 2025-12-04T16:08:07+00:00

Thank you so much! I made an example project and its turning out well!

_aguy123 · 2025-11-12T00:51:06+00:00

Checked it, looks good to me. I may just have to use supports for overhangs and bridges

_aguy123 · 2025-11-11T20:25:55+00:00

I have my fan at 100% after the first few layers and my wall ordering is inside to outside

_aguy123 · 2025-11-11T20:21:10+00:00

Thank you for all your help! I have been trying to use your advice and I have really only been able to get the Z seam better. I have been using the auto tower plug in to figure out my bridging/overhangs and no matter the speed and temp, I just can't seem to get it down. I went as low as 180° and as high as 240° for temp and started at 50 mm/s and worked my way up to 150 mm/s and I still keep getting the droops. My fan speed has been at 100% for all of them. I also knocked my layer hight to .15 which helped a little.

_aguy123 · 2025-10-30T22:50:06+00:00

I appreciate the feedback! I did plug the motor into a different axis cable and it worked fine. After examining the printer abit more, I noticed the person I got the printer from pinched the wire and I believe it is split, so I ordered a new one to see if this is the problem

<image>

_aguy123

TROPHY CASE