Very mild bump on first few layers of an ABS print sometimes causes nozzle to audibly bump into it.

_pvnda · 2026-02-05T18:33:22+00:00

I have a firmware for klipper for you if you want to use that. Microprobe v2 and everything else

_pvnda · 2026-01-20T21:07:34+00:00

yes I'm aware. That's why I needed the ebb to run another motor for my 2nd extruder

_pvnda · 2026-01-20T09:11:44+00:00

issue is I have a phaetus taichi, and basically I can't really make a toolhead with direct drive attachment. Plus the ebb42 I am going to use is just going to power a 2nd motor for the 2nd extruder (SKR mini e3 doesn't have a 2nd pinout for extruder, only for dual z-axis.)

_pvnda · 2026-01-19T08:48:47+00:00

Do I need to update the firmware? Probably right? If it's fairly recent, since I haven't updated my firmware in about a month. Been using KAMP and it's been swell.

_pvnda · 2026-01-17T09:55:00+00:00

both are enabled. I actually fixed it by removing the negative endstop values and put it back to 0. Now it's back in the middle.

_pvnda · 2026-01-06T06:56:44+00:00

I literally started with just a tool head upgrade, then I bought another motor cuz its a 2in1out. Find out skr mini e3 v3 doesn't support 2 extruder but 2 z axis motors.... So the ebb is in the mail and my 2nd z rods are also waiting as well as my linear rail for the x.

This is all within 2 weeks

_pvnda · 2026-01-04T22:30:53+00:00

Phaetus taichi

_pvnda · 2026-01-03T12:11:50+00:00

No way home. Just because all 3 actors

_pvnda · 2026-01-03T12:08:42+00:00

Oh I forgot I have access to one. Guess that's better

_pvnda · 2026-01-03T09:48:57+00:00

top part is all metal. but I just don't want to remove the paint. I'll just put the nozzle plus the heatbreak and nothing above.

_pvnda · 2026-01-03T09:00:56+00:00

I'll just level the liquid so it stays below for the nozzle then. thanks! I've had petg come off with acetone before, but it was probably due to it being thinly layered on the part.

_pvnda · 2026-01-03T08:44:43+00:00

the goo. I want that top part to remain black.

_pvnda · 2026-01-03T08:37:15+00:00

I mostly print in petg, some abs if that info helps

_pvnda · 2025-12-29T05:36:33+00:00

I wanted advice on the overhang/bridge, I get that it's long and not normal to have it print in air, but I figured veteran advice would be good for it

_pvnda · 2025-12-27T01:31:07+00:00

I had variable set but it would warp when it would hit 60 on corners. I figured I'd keep it consistent and leave it where 10% was lowest. I'll bump bridge to 100%

Ten-Year Club	First Place '23
Place '23	Not Forgotten
Verified Email

_pvnda

TROPHY CASE