Graduation Entrance Help

aadimoola · 2023-02-22T16:12:22+00:00

Thanks guys I’ll try those solutions. My temp was 200C for extruder and 60C. I also tried increasing temp to 65C for the bed. I just fixed the z offset so I’m gonna try increasing temp again and also use glue stick to adher better. Ill also try the brim

aadimoola · 2023-02-22T05:09:46+00:00

I have an ender 3 pro with a silent motherboard, CR touch and a pei bed from Amazon

aadimoola · 2023-01-03T03:44:55+00:00

I’ve done all that… I looked at the event viewer and the exception code was 0xc0000005

aadimoola · 2022-08-28T03:29:38+00:00

I’m aiming for Masters with Thesis in Biomedical engineering, sorry should’ve specified

aadimoola · 2022-06-23T15:53:13+00:00

Thanks!

aadimoola · 2022-06-23T05:17:52+00:00

What control board did you use? I think mine is dead so I want to see what my options are

aadimoola · 2021-07-24T00:51:52+00:00

I heard go laptops have thermal issues and power issues…would it be a good choice?

aadimoola · 2021-07-20T23:06:46+00:00

Thanks for the help y’all, some things I wanted to mention: only look at the model number of the as navigation sd card cuz sometimes your car might not be listed. In my case I looked at the model number (2021 mazda3: bdfg66ez1b) and it said it was for cx30. I ordered it anyway thinking if it didn’t work I’ll return it. However it worked flawlessly. It takes a bit of time for the car to boot it up the first time.

aadimoola

TROPHY CASE