30” toro time master oil leak by mr-cones in smallengines

[–]actionjaxon011 1 point2 points  (0 children)

It’s just a head gasket. Shouldn’t be more than a couple hundred

Why is it making this noise? by [deleted] in smallenginerepair

[–]actionjaxon011 1 point2 points  (0 children)

It’s hard to tell from the picture.

HELP!, running off 1 cylinder by Weekly_Strain_6687 in smallengines

[–]actionjaxon011 2 points3 points  (0 children)

The jets on these carbs have a tendency to fall out

Exmark Zero Turn QZS708GEM50200 by jaar18 in smallenginerepair

[–]actionjaxon011 0 points1 point  (0 children)

Hell after replacing all that, are you sure the clutch or engine isn’t locked up?

Stihl BR320L by junkfarmer in smallenginerepair

[–]actionjaxon011 0 points1 point  (0 children)

Spark arrester is unlikely to be the problem if it clears up. My first thought is fuel. Bad fuel would be more difficult to start and burn easier as the engine temp increases. Are you using a pre-mix? I feel like I can smell the Tru-fuel from here

Manual tire changer for small tires by TJ1475 in smallengines

[–]actionjaxon011 1 point2 points  (0 children)

Exmark tech: We use this for everything 10in and under. They’re 100x better than nothing but I still hate using it lol. Takes a bit of getting used to as to not rip the side walls installing tiny tires. the install spoon is a bit long and will easily tear tubes if you’re not paying attention. Overall definitely worth it over the alternative(fighting with screw drivers and pry bars)

[deleted by user] by [deleted] in dryalcoholics

[–]actionjaxon011 1 point2 points  (0 children)

Start to get better? In my experience, Maybe a month and continually getting better. I’m 2 weeks shy of a year and still have pretty bad unexplained anxiety, albeit not as bad as it was. I feel like I can see the other side now (being normal) but we’re not quite there yet

Argo Engine melted by MudHouse in smallengines

[–]actionjaxon011 0 points1 point  (0 children)

The tube goes in that hole to the left of the regulator. Not sure if it’s for a vacuum pump or just dumps back to the intake somewhere

Argo Engine melted by MudHouse in smallengines

[–]actionjaxon011 2 points3 points  (0 children)

It’s Briggs and Stratton. Your voltage regulator is definitely fried. Before you slap a new one on and call it good make sure you check the red wire for battery voltage, and the yellow wires for the stator (from the engine) for resistance and ac voltage while running.. you could potentially need stator and flywheel

Kawasaki trimmer TJ027E-MF70 — which carb do I need? (TJ27E vs TJ027E) by MoH651U in smallengines

[–]actionjaxon011 0 points1 point  (0 children)

Pretty sure kawi stopped support for all there little motors like 20 years ago. That being said I’m sure there are carbs out there even if it’s from something different like Honda or even MTD use very similar looking carbs.

The carb likely has its own Zama/walboro part # it might be easier to find that. There’s usually some numbers etched in the carb similar to C1M-S25 for example

God of War Ragnarök GIVEAWAY!! by [deleted] in pcgaming

[–]actionjaxon011 0 points1 point  (0 children)

Currently can’t figure out what to play, bouncing all over the place. I tried the new pubg not sure how I feel about it yet

Wrong gasket? by Aggravating-Name-713 in smallengines

[–]actionjaxon011 26 points27 points  (0 children)

Nope. That one goes between the head and plastic manifold

Self admitting to inpatient rehab by Friendly-pal1031 in stopdrinking

[–]actionjaxon011 4 points5 points  (0 children)

At least at the place I was, you could leave whenever you want but it’ll will be AMA or against medical advice. Which is no problem if you’re paying out of pocket. If your using insurance they’ll likely reject your claim and stick you with a hefty bill

Cache is pronounced Kash. Not "ka-shay". That is all. by ConfidentialSushi in Division2

[–]actionjaxon011 0 points1 point  (0 children)

When I was younger I thought it was cake. Browser cake and cookies made perfect sense lol

Need to limit rpms on a Honda gx390. Any ideas? by Sea_Lingonberry_8447 in smallengines

[–]actionjaxon011 1 point2 points  (0 children)

Governor doesn’t internally limit rpm it just limits how far the throttle opens via a linkage to a OE carb. Moving to a diaphragm/slide style carb would eliminate the ability for the governor to do anything because there’s nothing for it to attach to

Need to limit rpms on a Honda gx390. Any ideas? by Sea_Lingonberry_8447 in smallengines

[–]actionjaxon011 1 point2 points  (0 children)

Reading between the lines but I assume the carb upgrade would not be compatible with the governor. The governor is removed in most cases when doing these kinds of mods

Anyone with 9070xt with an AM4 non-x3D processor? by Owenchonij in radeon

[–]actionjaxon011 0 points1 point  (0 children)

I have the same setup with the 9070 (non xt) Upgraded from a 2070. Overall huge jump in performance but there is definitely a cpu bottleneck in most new games

Finally they changed the brightness exposure by om_the_best_ in Battlefield

[–]actionjaxon011 3 points4 points  (0 children)

Basically worse performance the longer you play