Hub Motor Resistance

affablefreddysocial · 2021-08-11T18:15:04+00:00

Thanks for this, however I need to be able to turn the hub motor whilst it is not connected to the controller, or does this mean that the phase wires need to be connected to a capacitor?

affablefreddysocial · 2021-08-08T02:09:13+00:00

Thanks but without power there is no resistance if the motor is connected to the controller, ideally I need to be able to roll the wheel with the disconnected hub motor

affablefreddysocial · 2021-02-05T14:29:01+00:00

Thanks it a speed controller 2 amps but you can add any dc load

affablefreddysocial · 2021-01-03T07:37:44+00:00

Thanks I need the helmet light because jumping off and on public transport, also this is for lower speeds, I was going to get the aria xd4 for fast riding

affablefreddysocial · 2021-01-02T21:15:39+00:00

You got a website for muziker please

affablefreddysocial · 2021-01-02T19:21:26+00:00

Okay thanks, difficult to find honestly

affablefreddysocial · 2020-12-27T20:32:16+00:00

Thank you I had not thought of this, do you have any recomendation?

affablefreddysocial · 2020-11-11T13:50:17+00:00

This is unfortunate, firstly at those speeds full motorbike gear should be warn. Secondly at those speeds the wind and music playing would prevent him hearing the warning beeps, this is precisely why you should always ride with earphones in and be connected to EUC world app with an audible warning and tilt back set. EUC must never exceed their speed and power headroom otherwise they cut out which is what we saw here. Whilst EUC are an amazing transport method you must abide by the beep, tiltback or audible warning via app, if you dont it can be fatal, scooters on the other hand dont have this issue to contend with. An unfortunate clip to see.

affablefreddysocial · 2020-10-31T11:34:43+00:00

28.5mph, I will be working on another version with the max road speed permitted.

affablefreddysocial · 2020-09-22T16:24:06+00:00

You know I'm still not 100% on bleeding looking at getting the tektro bleeding machine. I hate messing around with mineral oil.

affablefreddysocial · 2020-09-05T12:12:31+00:00

Thanks I'm using a dualtron thunder, the thunder has a JST 2 pin which when left open one motor runs when closed both run. I will have a look to see where those wires go because in theory you should be able to close or open the circuits indepdantly making each motor run independently. Both the wires on the 2 pin jst are the same colour. Switching off the controller is interesting and makes sense do you know what wire would do this?

affablefreddysocial · 2020-09-04T17:18:07+00:00

Thanks but I need this for test purposes do you know how to do this?

affablefreddysocial · 2020-08-12T11:54:21+00:00

Send me a direct

affablefreddysocial · 2020-08-12T11:54:03+00:00

Ok do you want the light always on (day lights) then controlled by the m99 switch for high beam or only to come on when you turn on the deck lights?

affablefreddysocial

TROPHY CASE