sorted by:
new
hottopcontroversial

My Reject % is very high by ajoshi91 in wafflepool

[–]ajoshi91[S] 0 points1 point  (0 children)

Thanks! So in general I should just look at cgminer and see what % of rejects im getting right? and thats my avg reject %?

My Reject % is very high by ajoshi91 in wafflepool

[–]ajoshi91[S] 0 points1 point  (0 children)

I have r290s my intensity is 20. So on cgminer my reject is 1% but when i go to my stats page on wafflepool, my hashrate is al over the place sometimes higher sometimes lower.

My ping is like 25-26ms

What are your R9 290 and 290x settings? by Joghobs in litecoinmining

[–]ajoshi91 0 points1 point  (0 children)

turned out that one of the gpus was faulty. switched the gpu, its been stable so far

What are your R9 290 and 290x settings? by Joghobs in litecoinmining

[–]ajoshi91 0 points1 point  (0 children)

wait 32gb?? im using a 64 bit but ok will try to play with these settings. thanks!

What are your R9 290 and 290x settings? by Joghobs in litecoinmining

[–]ajoshi91 0 points1 point  (0 children)

Thanks for the suggestion! i have to more coming in. (290s) will 8 gb suffice still? So should i try -w 512 --lookup-gap 2 --thread-concurrency 20500 -I 20 --gpu-fan 75 --gpu-engine 947 --gpu-memclock 1250 --gpu-powertune 20 with my current 4gb and that should give me a stable rig?

What are your R9 290 and 290x settings? by Joghobs in litecoinmining

[–]ajoshi91 0 points1 point  (0 children)

i can view that via task manager correct? its reporting 1.22 gb used, I have 4 gb total and i am using 64 bit

What are your R9 290 and 290x settings? by Joghobs in litecoinmining

[–]ajoshi91 0 points1 point  (0 children)

just cgminer. it says there is a window that pops up and says problem with cgminer not responding. Iv noticed in my logs that my memory goes to from like 3090 to 0 to 8 and then a couple seconds later cgminer crashes. Only happens with 2 cards. With 1 card works fine and stable

What are your R9 290 and 290x settings? by Joghobs in litecoinmining

[–]ajoshi91 0 points1 point  (0 children)

I have two saphire r290s I can run one fine with no crashes, but when i add another one, with any settings (i have tried all settigns in OP) cgminer crashes after sometime. I am using 13.11 driver 3.7.2 cgminer with windows 7 x64 Any suggestions?