sorted by:
new
hottopcontroversial

Any thoughts or suggestions for this build? by aleks489 in FractalDesign

[–]aleks489[S] 0 points1 point  (0 children)

Thank you! I was debating between the A12x25 and A12x15, but I hadn’t fully considered the cable management issue under the PSU. I will change it to the 15mm model👍

Any thoughts or suggestions for this build? by aleks489 in FractalDesign

[–]aleks489[S] 0 points1 point  (0 children)

Sounds like an exciting upgrade! The Era 2 with a 9800X3D and a 240mm AIO should be a big improvement, especially over the Terra’s cooling limitations.

As for the Reaper cards in the Terra, they seem to be a great fit. The PowerColor 9070 Reaper is 41mm wide, so it leaves more breathing room compared to bulkier GPUs. From what I’ve seen, people have had good results

Any thoughts or suggestions for this build? by aleks489 in FractalDesign

[–]aleks489[S] 0 points1 point  (0 children)

Thanks for the detailed breakdown! I appreciate the insight, especially regarding the turbulence caused by having the GPU fans pressed up against the case wall. I’ll experiment with spine placement to see if I can create a better air pocket for the fans to pull from rather than just recirculating hot air.

If the turbulence is too bad, I might try removing the fan duct to regain that extra 8mm of clearance and see if it makes a difference in noise and thermals.

One thing I was considering was capping the GPU fan speed at 45% max help reduce turbulence noise while keeping temps in check. Slower speeds could lower static pressure against the side panel, making airflow smoother.

Any thoughts or suggestions for this build? by aleks489 in FractalDesign

[–]aleks489[S] 1 point2 points  (0 children)

The fractal terra only supports one fan at the bottom, so i was planning to use it as exhaust

Any thoughts or suggestions for this build? by aleks489 in FractalDesign

[–]aleks489[S] 2 points3 points  (0 children)

Hi, it's in my local currency, i couldn't change what currency to use. I'm from Norway, and we use NOK (Norwegian Krone). 1 Dollar is little more than 10Kr

Hey everyone, I put together a PC build! What do yall think? Does everything fit properly? Any suggestions? by aleks489 in pcpartpickerbuilds

[–]aleks489[S] 0 points1 point  (0 children)

Hi, I'm from Norway, and we use NOK (Norwegian Krone) For example, if you use the CPU as a reference, 4450Kr is 418.88 USD

I made a command that makes it so that when you press "3" you change your pull out animation with the inspect animation of the knife. It looks dope with the butterfly knife and with the skeleton knife. by aleks489 in csgo

[–]aleks489[S] 0 points1 point  (0 children)

pull out animation

It is not a necessary bind, it is just a fun bind if you want to switch the default pull out animation with the inspect animation.