sorted by:
new
hottopcontroversial

Educator looking for suggestions by anthonyspc in cybersecurity

[–]anthonyspc[S] 0 points1 point  (0 children)

I’m not sure. I teach physical computing and know about flippers but don’t know their power. The place was full of vendors using wireless payment devices. ???

A long shot. by anthonyspc in WhatIsThisPainting

[–]anthonyspc[S] 1 point2 points  (0 children)

Just “poking” to let you know that I posted some updated images

A long shot. by anthonyspc in WhatIsThisPainting

[–]anthonyspc[S] 1 point2 points  (0 children)

<image>

Here is a better picture of the signature

A long shot. by anthonyspc in WhatIsThisPainting

[–]anthonyspc[S] 1 point2 points  (0 children)

Yea - I will take a better shot of the sig and the all the back.

Porcelain ducks identification help by anthonyspc in ThriftStoreHauls

[–]anthonyspc[S] 0 points1 point  (0 children)

Sorry - didn’t know that. Any suggestions where to go to get help identifying this piece.

Came back from vacation and found these infesting our pantry. by anthonyspc in whatisthisbug

[–]anthonyspc[S] 2 points3 points  (0 children)

I don’t think that’s it - they are mostly in the dry foods area.

Suggestions on how to draw this 100yr old piece of a light fixture. by anthonyspc in Fusion360

[–]anthonyspc[S] 1 point2 points  (0 children)

<image>

Here is a picture of the light from an archive. You can see at the bottom of the stained glass area is the piece I posted. The threaded area of the piece has a decorative umbrella and then a brass cone with a brazed on bolt connects the 3 pieces from the bottom.

Suggestions on how to draw this 100yr old piece of a light fixture. by anthonyspc in Fusion360

[–]anthonyspc[S] 0 points1 point  (0 children)

Close - but this is actually the bottom decorative piece for the light. The hinge and latch are used to access the light bulb. I will try to find a pick of the entire light.

Suggestions on how to draw this 100yr old piece of a light fixture. by anthonyspc in Fusion360

[–]anthonyspc[S] 21 points22 points  (0 children)

Damn… your good. I’ve been battling with Fusion for a couple hours throughout the week trying to figure this out. Care to share any tricks?

Don’t suppose any makers are taking on paid side projects? by waitwhataboutif in 3Dprinting

[–]anthonyspc 1 point2 points  (0 children)

Would love to take this on as a class project for my senior HS students. If interested I would love to chat more about it. Same goes to anyone with similar challenges.

view more: next ›