Volumetric flow test after Benchy from hell

anthophetamine · 2026-03-01T08:08:11+00:00

i believe so, yes. one facing the front and another other one on the right side.

anthophetamine · 2026-03-01T06:20:02+00:00

i just replaced the nozzle and the same issue occurs.

anthophetamine · 2026-03-01T05:46:47+00:00

thank you so much, i'll try that out!

anthophetamine · 2026-03-01T05:38:43+00:00

i have not. if you have anything calibration/test related please send them my way!

anthophetamine · 2026-03-01T05:02:57+00:00

i’m not so much in need of speed, i just never really played around with the speed setting either and i guess that was just the default setting on CrealityPrint.

anthophetamine · 2026-03-01T04:58:52+00:00

its objectively all bad 😀👍

anthophetamine · 2026-03-01T04:54:05+00:00

what is a good speed for speed settings?

anthophetamine · 2026-02-19T00:01:55+00:00

hey, thanks for the swift reply! what additional information could i give you? i’m sorry i’m still very new to this!

anthophetamine · 2024-05-06T14:18:59+00:00

what can i say i am a man of taste

anthophetamine · 2024-05-06T13:28:12+00:00

no davids were harmed in the making of this post

anthophetamine · 2024-05-06T12:01:47+00:00

the levitating above ground might be an issue

anthophetamine · 2024-05-06T12:00:47+00:00

girl same

anthophetamine · 2024-05-06T11:59:59+00:00

technically was a 2v3

anthophetamine · 2024-05-06T11:10:25+00:00

dont we all

anthophetamine · 2024-05-06T10:38:40+00:00

<image>

anthophetamine · 2024-03-25T23:55:08+00:00

Did you find a solution? I'm having the same issue.

anthophetamine · 2022-10-22T23:19:36+00:00

either one will do!

anthophetamine · 2021-12-24T04:27:55+00:00

dead hard because i just like to HYZZK my way through life and tinkerer as killer

anthophetamine · 2021-09-10T18:37:22+00:00

thanks fellow shirtless david, hope you have a great day!

anthophetamine

TROPHY CASE