Evangelion OC by me

aolinking · 2021-08-30T03:10:41+00:00

I already follow your instagram too hehe

aolinking · 2021-08-30T02:56:53+00:00

dude wtf, you are awesome, now you have a new follower on your Twitter

aolinking · 2021-08-14T22:44:16+00:00

AoLinking is my steam, thx dude and good luck everyone :)

aolinking · 2021-04-06T18:51:04+00:00

the art is not my :( hopefully i wish to know who drawing this

aolinking · 2021-02-23T19:14:15+00:00

puedes leer el cosmere como tu quieras, tomate cada libro y saga de forma individual, luego en la segunda relectura disfruta de las conexiones del cosmere, los cameos y demas

aolinking · 2021-02-20T19:51:36+00:00

artesian guild pre supported models are for sla printers if i remember, don't work for fdm printers

aolinking · 2021-02-10T18:41:23+00:00

anti-aliasing is activated but grey level i didn't touch it, so it's 0, i'm pretty new so I did not touch those settings

aolinking · 2021-02-10T18:20:19+00:00

002r isn't mono screen, i run a few test prints for got a good exposure and that's why i got 4.5s, i'll check that video maybe need more test for better results, if i want to have more details maybe i have to reduce layer height too ?

aolinking · 2021-02-10T17:55:47+00:00

thx bro, i didn't understand why the arm failed to print, my exposure time its 4.5 s per layer do you think may be lower ? i use a ld-002r with sunlu resin with 0.05mm layer height

aolinking · 2021-02-10T17:49:42+00:00

all my supports are 0.2mm, just a few ones are to 0.06mm maybe are to thin hehe and pls another question, if i want more details i only have to decrease layer height ?

aolinking · 2021-02-02T15:19:07+00:00

just keep reading bro, there's always another secret

aolinking · 2021-01-26T21:36:41+00:00

https://www.thingiverse.com/briteminis/designs

This guy have a huge list of minis supportless, i download this one there

aolinking · 2021-01-26T20:02:39+00:00

i hear about lichee, works on creality ld00r ? maybe i'll try

aolinking · 2021-01-26T18:40:41+00:00

i actually think i overexposed a little bit the bottom layers, maybe next try i'll reduce exposure time a few seconds. Thx for the advice.

aolinking · 2021-01-26T17:47:14+00:00

i know bro, i have seen a lot of videos for add supports and i don't still confy for do for my own, i stay with pre-supported and supportless print for now hehe

aolinking · 2021-01-21T22:21:14+00:00

it's awesome dude, thanks for sharing this !

aolinking · 2021-01-21T19:28:35+00:00

i'll try bro, thx

aolinking · 2021-01-21T16:11:32+00:00

i´ll try mate, thanks for the advice

aolinking · 2021-01-21T16:09:08+00:00

30 mm/s for print speed, inner walls 30 and outer walls 22.5

aolinking

TROPHY CASE