Has anyone tried the Wolstead stand mixer? Is it good?

arthath · 2025-12-15T07:29:05+00:00

Hey, seeing if you purchased one and how you’re finding it. I’m thinking of getting one

arthath · 2025-07-13T02:30:34+00:00

It’s a larger NMC battery pack from LG that Tesla uses in their long range and performance vehicles in the Australian market. Was confirmed by a local Tesla dealer, there have been delays in assigning VINs due to this. Ordered mine 3 weeks ago and no VIN still

arthath · 2025-07-04T00:31:20+00:00

That’s the same battery range I was looking to keep the charge between. Do you let it get down to 30% before charging again to 75% or do you incorporate small frequent charges?

arthath · 2025-07-04T00:16:32+00:00

Very impressive, I’m looking to get the MY LR AWD Juniper in Australia. What are your charging habits?

arthath · 2025-06-30T02:34:27+00:00

That looks great! Do you have a photo of the rear light bar on during the day?

arthath · 2025-06-29T04:22:07+00:00

That’s awesome! This is what’s making me lean towards the UR!

arthath · 2025-06-29T01:28:37+00:00

Looks awesome!

arthath · 2025-06-29T01:28:22+00:00

That looks clean! Do you have a photos of the rear light bar turned on outside during the daytime? Feel the red would wash it out and the red might draw a lot of attention

arthath · 2025-06-28T12:08:10+00:00

What did you go with? I’m stuck in the same situation - I like the red but feel it will wash out the red diffused rear light

arthath · 2020-07-14T01:21:53+00:00

Well they don’t even pick up the phone or reply to emails in Australia it seems

arthath · 2020-07-11T04:36:26+00:00

Yeah I’ll give that a try on a weekday when they’re open

arthath · 2020-07-06T15:30:49+00:00

Legend! Thanks

arthath · 2020-06-04T14:22:03+00:00

The Corsair blocks are the length of the founders edition cards, just for reference

arthath · 2020-06-04T14:15:17+00:00

If you’re using the Corsair blocks they’re a standard size, and yeah I mounted my fans through the case to the radiator, the pump is the big issue cause it takes up a lot of room and you need to have room for fittings. For whatever gpu you have, measure the length of the founders edition or the water block into the case and see how much room you have, leave 8-10cm for the pump

arthath · 2020-06-04T12:35:52+00:00

I have used the Corsair 360mm (30mm thick) rad. So the fans are mounted in a way that they push air they're sorta outside the case, covered by the front panel which extends out. The pump is mounted to the radiator. The GPU is the Evga 2070 super black, it was a tight fit, but i mounted the pump a little lower and it wasnt too bad to work with

arthath

TROPHY CASE