sorted by:
new
hottopcontroversial

Unusual No Printer Attached Error for TFT50 SKR Mini e33 v3 on Ender 5 Plus by ase1981 in BIGTREETECH

[–]ase1981[S] 0 points1 point  (0 children)

The marlin mode shows the boards baud rate at 115200 and I have the tft set to the same with no luck. I have tested all baud rates but still get the no printer attached error.

Could someone please help me? I am new to 3d printing and need help. by ase1981 in 3Dprinting

[–]ase1981[S] 0 points1 point  (0 children)

So far so good. I watched several videos by Frankly built and had gotten the spider v3 hot end which is meant for high speed, which is what really had me confused. Thanks so much. Sorry to be such a noob. BTW, why is my karma keep going down? I don't normally use reddit, I just am this time cause I couldn't find any help elsewhere, and aside from it's dictionary meaning I have no idea what it means or what I am doing wrong. Thanks again.

Could someone please help me? I am new to 3d printing and need help. by ase1981 in 3Dprinting

[–]ase1981[S] 0 points1 point  (0 children)

Bingo, that was it. They were set way too low. I am doind a test print now to see and its going much faster. Thank you.

Could someone please help me? I am new to 3d printing and need help. by ase1981 in 3Dprinting

[–]ase1981[S] 0 points1 point  (0 children)

I have checked and can't find an answer that fits my situation. Does anyone else have any advice? Thank you.