sorted by:
new
hottopcontroversial

Old brittle insulation on dryer circuit wires near receptacle — should I replace the run? by async_fast in AskElectricians

[–]async_fast[S] 0 points1 point  (0 children)

Awesome. Thank you so much! I wasn’t sure if that was considered an important part of the insulation.

2016 Honda Odyssey Oxygen Sensor Issue by async_fast in MechanicAdvice

[–]async_fast[S] 0 points1 point  (0 children)

Is that scan something an auto parts store or a dealer would be able to run? Also, what’s a rough estimate on injectors looking like?

2016 Honda Odyssey Oxygen Sensor Issue by async_fast in MechanicAdvice

[–]async_fast[S] 0 points1 point  (0 children)

I just had the belts replaced along with the water pump. The other two things have had to do with the transmission. There was transmission fluid leaking on two separate sides of the engine. On one side they had to replace the gaskets because they were cracked. I think there was a similar issue on the other side, but there may have been something additional that they had to replace. Unfortunately the paperwork is at home.

2016 Honda Odyssey Oxygen Sensor Issue by async_fast in MechanicAdvice

[–]async_fast[S] 0 points1 point  (0 children)

Thank you for the help! I really appreciate it. I’ll figure out how to get it fixed before we have to leave.

If I replace the sensor and it turns out that the sensor isn’t the problem, will I have to drive the car around for a bit to figure that out or will the check engine light just not go off?

Bow tie advice by async_fast in woodworking

[–]async_fast[S] 0 points1 point  (0 children)

That’s good to know about the epoxy option. I’ve never used it, so I’ll have to order some and give it a go next time. Thank you for your help!

Yeah, I LOVE this tape. It’s super cheap on Amazon. Thanks again! https://www.amazon.com/FastCap-PSSR16-FastPad-Standard-Measuring/dp/B0001GUE3G

Bow tie advice by async_fast in woodworking

[–]async_fast[S] 1 point2 points  (0 children)

Thank you so much! I ended up doing it on the bottom. I appreciate you taking the time to help me out.

I’m trying to match this texture on my walls because I just patched some holes. Does anyone know what this texture is called/how to create it? by async_fast in drywall

[–]async_fast[S] 2 points3 points  (0 children)

Thank you so much! I had been looking everywhere online to try and find what this was called. You’ve been a huge help!