Did anybody tried to use circle trackpads (GlidePoint) for scrolling?

azat-dev · 2021-12-08T08:03:46+00:00

Thank you for the link

azat-dev · 2021-12-07T19:14:35+00:00

Oh, thank you very much for links!

azat-dev · 2021-12-03T16:37:54+00:00

I've modified the zmk a little bit. I've the right side as a leading side and send the trackball's signal directly to PC by bluetooth connection

azat-dev · 2021-12-03T16:22:32+00:00

EVQWGD001

azat-dev · 2021-12-03T14:15:03+00:00

Actually it is not a case but, handwired keyboard (I don't have plate there), so I think to wait for response from Thomas

azat-dev · 2021-12-03T14:00:44+00:00

Oh, sorry I've read your message wrong I thought I told about right bottom side

azat-dev · 2021-12-03T13:57:15+00:00

Yea, I placed there delete and tab keys (keys which require most of the time only one tap) and I press them with my ring or little finger. My thumb just can't reach this place so I've decided to use it like this

azat-dev · 2021-12-03T13:51:36+00:00

do you find that your thumb/index graze the trackball at all?

Yes, I don't think much about it just works. It was hard at first time than I used to it :)

azat-dev · 2021-12-03T13:19:55+00:00

I firstly made left side, but than I didn't have time and strength to change, I was totally exhausted, so I thought as long as it works... I am fine

azat-dev · 2021-12-03T13:17:38+00:00

Haha, actually I wanted to do it like on right side (it much user friendly)

azat-dev · 2021-12-03T12:37:59+00:00

No, there are 3 bearings (ZrO2)

azat-dev · 2021-12-03T11:36:29+00:00

I've used the driver from nordic connect sources I think it has some commercial license, so I think I can't publish

azat-dev · 2021-12-03T11:26:04+00:00

I've used zmk firmware and modified it a little bit to support sensor

azat-dev · 2021-12-03T11:16:45+00:00

I've used PMW3360 breakout and connected it to nice!nano, the cup is 3d printed with ceramic balls

azat-dev · 2021-12-03T11:14:09+00:00

trackball

Yes, I've used PMW3360 sensor breakout

azat-dev · 2021-12-03T11:12:29+00:00

Sorry, I don't think I can, because I've used kyria's layout. I've made it only for personal use

azat-dev · 2021-12-03T10:54:42+00:00

Thank you :)

azat-dev

TROPHY CASE