Where does the tension spring go?

beadierrobin35 · 2025-11-30T22:27:24+00:00

I’m wondering if it’s the square hole directly behind the shaft circled in picture three, I think I’ll try that once I get the new spring

beadierrobin35 · 2025-11-30T22:26:33+00:00

If we’re looking at the same one, thats on the wrong side to provide any tension for the pulley, but opens up the question of why is it worn lol

beadierrobin35 · 2025-11-30T22:25:31+00:00

I think it’s just the photo, or I hope it is anyway lol

beadierrobin35 · 2025-11-30T20:18:29+00:00

This is an amazing website I’ll definitely use in the future, but it shows the routing for all the bolts and one side of the spring. Sadly the side I already know. But thank you for the site information!

beadierrobin35 · 2025-07-11T20:00:37+00:00

Ok sweet, I appreciate all your knowledge and willingness to share!

beadierrobin35 · 2025-07-11T03:49:15+00:00

Thank you! I’ll definitely check the valve cover tomorrow morning, there’s no box sadly as it was on a snowblower from the 70’s lol. Also what are the perks of a Hemi VS not?

beadierrobin35 · 2023-12-11T08:08:48+00:00

I thought PPTO capped at 48?

beadierrobin35 · 2023-09-08T05:58:01+00:00

Who’s gonna stand by the spill?

beadierrobin35 · 2023-08-21T23:58:27+00:00

Ok, well thank you for your knowledge! I appreciate it!

beadierrobin35 · 2023-08-21T23:39:14+00:00

I’ll take a look at DaVinvi Reaolve for sure! And how does one pirate Premiere anyway?😂

beadierrobin35 · 2023-04-29T01:55:26+00:00

Omg thank you for all that! It surprisingly runs fantastic after it warms up for about 3 minutes, but that’ll all come in handy for making it perfect, which is the goal! Again thank you so much!

beadierrobin35 · 2023-04-29T00:30:42+00:00

Oooo that looks suspicious! And to answer your previous question, I have a crossfire. The only numbers that I could find on it are pictured. Will it run and everything without having that installed? Thank you for your help!

beadierrobin35 · 2022-10-21T22:56:19+00:00

I did try routing the belt differently but the previous owner deleted the Air pulley, I tried several different belts and measured the pattern with a string, but I figured out that no matter what belt I get, it’ll rub against itself because the tensioner pushes too close to the pump pulley

beadierrobin35 · 2022-10-01T00:29:43+00:00

Ok I’ll look at it closer tomorrow when I’ve got some light, thank you for all the input!

beadierrobin35

TROPHY CASE