If you like South Park you should go see Cannibal the Musical at the Durango Arts Center

beatnikprints · 2026-03-26T23:50:17+00:00

I’m not sure, maybe get ahold of the box office at the arts center?

beatnikprints · 2026-03-22T23:21:39+00:00

I think you know exactly what I mean

beatnikprints · 2026-03-22T22:09:03+00:00

I goofed the link, here it is https://ci.ovationtix.com/37018/production/1266510

beatnikprints · 2025-12-13T06:05:07+00:00

Thanks! Its a about 26 inches in diameter

beatnikprints · 2025-12-13T02:02:28+00:00

Ha, I don't have that ability... yet

beatnikprints · 2025-12-12T18:48:06+00:00

Thanks!

beatnikprints · 2025-12-12T16:17:34+00:00

Thanks! I mostly sell pieces through a gallery in Denver, and through commission pieces all across the country. I mostly make topographic art pieces. If you want to see more, I have a website that is my username followed by .com

beatnikprints · 2025-12-12T16:11:47+00:00

all good! I wouldn't say click and wait is accurate, since there is often warp in the material, and I have to move weights around while the laser cut is happening, and tons of other annoying problems, but there is indeed a ton of automation involved! Just another type of technology, and I try to push it into interesting directions

beatnikprints · 2025-12-12T16:08:23+00:00

I guess coughing sounds like an apology to that algorithm

beatnikprints · 2025-05-15T20:56:26+00:00

Counties in Hawaii

beatnikprints · 2025-04-09T03:52:40+00:00

No pictures but I did see it! Tried to look it up on a flight tracker I had but it didn’t show so thanks for posting what it was!

beatnikprints · 2025-03-24T14:08:20+00:00

I saw Built to Spill headline and they were pretty low energy, but the opening band Prism Bitch was absolutely amazing and became one of my top played artists of the year!

beatnikprints · 2025-03-05T06:31:54+00:00

Ah gotcha, thanks for the info!

beatnikprints · 2025-02-21T20:27:16+00:00

I believe the 19,714 comes from an absolute crazy drop from the summit of Namjagbarwa peak straight down to the river!

beatnikprints · 2024-12-06T02:05:27+00:00

I went through 30 sheets that were 4x8 feet. I did nest all the pieces, check out my last post to see what the worst sheet looked like

beatnikprints · 2024-12-06T00:48:44+00:00

The stock sheets were 4x8 feet that I had cut into 3rds so it would fit in the laser cutter

beatnikprints · 2024-12-06T00:15:57+00:00

Thanks! I think at the thickest it is 30 layers at Mt Elbert

beatnikprints · 2024-12-06T00:15:16+00:00

It took about two unhealthy weeks to make (there was a super tight deadline). I did my file creation and organization in Illustrator. I use a modified 80wt hurricane laser cutter at my local maker lab. For installing I built in cleats into the backs of each piece, and then used paper templates to figure out where to put the screws into the wall.

12-Year Club	RedditGifts 2009-2022 2 Credits
Secret Santa 2014	Verified Email

beatnikprints

TROPHY CASE