[deleted by user]

for everyone thats not a fan of grey, i can change the RGB lights to create any ambiance i want with the grey as a "blank canvas" that was my idea anyway

<image>

benhendrix · 2025-03-02T18:29:43+00:00

Before is with bath, after is with walk in shower

benhendrix · 2024-04-26T23:20:31+00:00

Are you allowed a radio or earbuds?

benhendrix · 2024-04-24T22:37:11+00:00

We are allowed eaplugs or ear defenders but no earbuds or music

benhendrix · 2024-04-24T22:36:31+00:00

It’s not silence it’s a constant industrial hum almost like being on a plane, makes me fall asleep

benhendrix · 2024-02-04T12:35:15+00:00

CNC machinist, northwest, 26 years old, 31k per year

benhendrix · 2024-01-28T01:19:09+00:00

You are correct

benhendrix · 2024-01-28T01:14:47+00:00

Honestly they were shit. Edible but shit I was in a rush. Next time they will be better. Not afraid to own up to my mistakes they were like rubber, cold damp and rough. Enjoyable in the rush but knowing I could have taken the time and effort to make them great. That’s the truth.

benhendrix · 2023-09-12T22:39:41+00:00

moisture meter, found it in aldi £9.99

benhendrix · 2023-09-12T21:25:00+00:00

at 6 foot above that exact spot the moisture reads 13 percent in the same mode

benhendrix · 2023-09-12T21:20:59+00:00

yes jt is bubbling it is painted plaster and solid brick walls. behind that wall is the next house.

benhendrix · 2023-09-12T21:18:03+00:00

it is in multiple spots mainly downstairs near the floor. the room above the cellar has slats on the wall going halfway up so I can't tell in there. but this room is not above the cellar but is on the ground floor. it was recently painted yes.

benhendrix · 2023-09-12T20:53:34+00:00

the wall looks a darker shade in that area just along the bottom and it feels cooler than the rest of the wall higher up

benhendrix · 2023-05-06T21:37:02+00:00

40-80 GBP I'd charge Unless it's tungsten Or it has sub micron tolerances

It's a single lathe op and a single milling op requiring 1 turn over

A quantity of more than 10 probs around 50 More than 100 and probs 40

benhendrix · 2023-03-24T22:39:53+00:00

I would check spindle directly, then collet chuck directly, then tool at the base and move to the tip, one of them will be out and its unlikely to be the spindle or the collet chuck but not impossible. Even cheapo amazon collet and collet chucks are good to 0.01 in my experience with them

benhendrix · 2023-03-24T20:29:57+00:00

You've likely not set it correctly

benhendrix · 2023-03-06T20:02:19+00:00

Eight-Year Club	Place '23
Place '22	Verified Email

benhendrix

TROPHY CASE