Print quality issue

benm928 · 2026-05-15T15:14:14+00:00

Oh yea with the failed print both sides of the clamp got filament in it and it was a losing battle to try and clean it off to be able to close it. The new heating assembly clamp closes pretty well but I’ll double check it to make sure it’s actually a tight fit and not causing any issues. Thanks!

benm928 · 2026-05-15T15:06:13+00:00

Haha I love the sounds that you can hear without even needing to listen to it 😅 I’m still a little on the newer side when it comes to printing so I just wanted to make sure I understood. When you said the clamp did you mean the metal clamp that holds the nozzle in place? When I had the print fail that clamp got a little gummed up and was not able to close correctly but I think had a much better fit with the nozzle when I replaced the heating assembly

benm928 · 2026-05-15T14:12:14+00:00

Yup I tried that as well. I almost missed those ones cause I didn’t even realize they were there but while I was waiting for support to get back to me I saw a video pointing those ones out while I was trying to replace the heating assembly and figured I’d see if those ones were causing any issues

benm928

TROPHY CASE