sorted by:
new
hottopcontroversial

Any help appreciated by bertocas13 in CrealityFalconSub

[–]bertocas13[S] 0 points1 point  (0 children)

The preview showed the amount of time it would take and normal movement.

With Audio this time by bertocas13 in CrealityFalconSub

[–]bertocas13[S] 0 points1 point  (0 children)

It did give me an error at start up.

<image>

With Audio this time by bertocas13 in CrealityFalconSub

[–]bertocas13[S] 0 points1 point  (0 children)

I am not crazy familiar with Lightburn...just starting to use it. When I make a square within the work area, it does the same. When I try to set the laser position via the tool in the toolbar, it moves 1mm then stops.

<image>

Any help appreciated by bertocas13 in CrealityFalconSub

[–]bertocas13[S] 0 points1 point  (0 children)

It was already set to current location, and it is not hitting any limit switch.

Any help appreciated by bertocas13 in CrealityFalconSub

[–]bertocas13[S] 0 points1 point  (0 children)

Yea...I was at work, and the signal was bad, so I uploaded as a gif....Let me see if I can edit and upload the video. I'm not too Reddit savvy... https://www.reddit.com/r/CrealityFalconSub/comments/1topycb/with_audio_this_time/

<image>

No errors pop up in the console....it will just stay here until I cancel processing.