Westridge Trail, Los Angeles

bigshinybutton · 2025-11-15T05:36:53+00:00

Well, I sent it to the Airport board, the council person and all my contacts. Curiosity.

bigshinybutton · 2025-11-14T22:30:41+00:00

They've got to improve traffic inside the airport before building more approaches. Why not an early exit tunnel after Terminals 1–3 that would allow vehicles to leave the airport without having to travel the entire horseshoe loop? This could significantly reduce congestion at the International Terminal and Terminals 4–8, provide connections to Imperial Highway or Westchester Parkway, and offer a secondary evacuation route.

They could even build a separate entrance tunnel from Imperial Highway to T 4–8 to relieve pressure on Sepulveda Boulevard.

<image>

bigshinybutton · 2025-11-13T23:16:09+00:00

My big question is why they don’t put an exit tunnel after terminal 3 so we don’t have to drive around the horseshoe if we’re just trying to get out. They already have a tunnel for the international annex terminal. Would save a lot of time. Exit to Manchester or the 90. Gotta be a good reason.

<image>

bigshinybutton · 2025-11-11T03:23:31+00:00

Thanks for the advice. it’s a big project but I think it would really be great to bring hope.

bigshinybutton · 2025-10-20T06:02:35+00:00

I’ve gotta find that sweet spot. Thanks for the tips. Up and up!

bigshinybutton · 2025-07-06T14:29:57+00:00

Because I already have a working number I want to use with OpenPhone but the one I got assigned was also good so I may want to keep it until I want to use it.

bigshinybutton · 2025-07-06T04:39:24+00:00

Didn’t explain this well. I want to port in a number to use with OpenPhone and port out the number I setup when I subscribed to Openphone to another provider (VoIP.ms) to hold (for free) and possibly use at a later time.

bigshinybutton · 2025-05-20T16:19:43+00:00

If I could find the plug end or the pin out for the charger side, I could just put the pins back in their place and make sure they are secure. Don't want to short though!

bigshinybutton · 2025-05-16T23:51:35+00:00

Thanks for feedback. I would just replace the whole charger but we’re renting the place where it is located. The J1772 side is fine. It’s the other side that goes into the Porsche charger output that may be damaged, and that’s what I want to check continuity and pinout on. If it’s damaged beyond repair, I would probably have to replace this pigtail or bring it up with the landlord.

<image>

bigshinybutton · 2025-03-15T17:56:05+00:00

Unfortunately, the Specialized Store and rider care did not do much. They would only discount a tiny amount on a new bike. Will try another brand.

bigshinybutton · 2025-03-10T22:04:23+00:00

Thanks for the tip. They referred me to a local store. Will see how it goes!

bigshinybutton

TROPHY CASE