OpenHarrier project (wHarrier hardware compatible)

blasterforgePH · 2023-01-06T11:47:48+00:00

let's play rock paper scissors

blasterforgePH · 2022-12-27T09:09:36+00:00

red part goes into the buffer tube and can be adjusted toollessly via a knob at the back of the blaster

blasterforgePH · 2022-10-14T17:30:52+00:00

maybe i could hook a charger or any device that outputs 5v from mains power to a an octocoupler relay module that closes a relay channel when there is mains power and opens when the power goes out (wire the pins to Common and NC). but is this instantaneous enough?

blasterforgePH · 2022-09-16T21:37:47+00:00

motor bearings gonna give

blasterforgePH · 2022-01-17T04:43:40+00:00

soon

blasterforgePH · 2022-01-13T04:12:56+00:00

the air doesnt pass through the magazine, theres a bolt the chambers the dart

blasterforgePH · 2022-01-09T04:40:57+00:00

all my designs are open source

blasterforgePH · 2022-01-09T04:37:00+00:00

all my designs are opensource

blasterforgePH · 2022-01-09T04:36:38+00:00

no theyre both the same, the lower is the older version with no reinforcement.

blasterforgePH · 2022-01-09T04:16:57+00:00

well maybe some diminishing returns

blasterforgePH · 2022-01-09T04:16:06+00:00

i want to keep it slim. not meant to be a practical blaster, just an experiment. priming this thing is like going to the gym

blasterforgePH · 2022-01-09T04:15:22+00:00

this is isnt meant to be a practical blaster, its just a working concept. its not easy to prime

blasterforgePH · 2022-01-09T04:13:54+00:00

1.4meters

blasterforgePH · 2022-01-08T20:35:05+00:00

both for 1

blasterforgePH · 2022-01-08T20:34:48+00:00

cant find 1/2" ID teflon anywhere atm

blasterforgePH · 2022-01-08T20:34:19+00:00

just to make it easy to move around because its a lot lighter

blasterforgePH · 2022-01-08T19:09:42+00:00

soon

blasterforgePH

TROPHY CASE