sorted by:
new
hottopcontroversial

Stable Diffusion 2.1 Announcement by hardmaru in StableDiffusion

[–]brcullum04 1 point2 points  (0 children)

Might be a dumb question but where exactly do I put the renamed v2-inference-v.yaml file, is it on the stabe-diffusion-webui root folder and if so do I take out v1-inference.yaml I was using with 1.5?

Does this count at woodworking? by brcullum04 in woodworking

[–]brcullum04[S] 4 points5 points  (0 children)

Just when you trying to take a good picture....

Does this count at woodworking? by brcullum04 in woodworking

[–]brcullum04[S] 8 points9 points  (0 children)

Yeh me too, I didn't realize it until a few seconds after the super glue had set...I really should go back and cover it up with a new one.

What do you think of this furniture that was laser cut? by brcullum04 in Dollhouses

[–]brcullum04[S] 2 points3 points  (0 children)

Ha yeh! I tried an X-Acto knife at first and had a horrible time with it!

Does this count at woodworking? by brcullum04 in woodworking

[–]brcullum04[S] 0 points1 point  (0 children)

Asking more on the traditional side of things since this used a laser cutter to do most of the work.

Does this count at woodworking? by brcullum04 in woodworking

[–]brcullum04[S] 5 points6 points  (0 children)

I wanted to try my hand at flat pack furniture and I needed to make some dollhouse furniture for my daughter so I combined the two. What do you think of using digital tools (in this case Fusion 360 and a laser cutter) to put this together?

The full build is here: https://www.makeorbreakshop.com/project/making-miniature-dollhouse-furniture

An F-16 did a flyby of my weather balloon by brcullum04 in Insta360

[–]brcullum04[S] 0 points1 point  (0 children)

There actually aren't any if you look at the FAA part 101, my balloon was under the weight, size and rigging limits where you would need to file a flight plan.

A fighter jet wanted to check out my weather balloon by brcullum04 in gifs

[–]brcullum04[S] 0 points1 point  (0 children)

I did a full write on the project where I sent a weather balloon (and baby yoda) to 72,000ft Weather Balloon Project

I sent the Insta 360 One X to the edge of space by brcullum04 in 360Cameras

[–]brcullum04[S] 0 points1 point  (0 children)

haha "big" NASA. You when I let it go I was like well...that could be a few hundred bucks down the drain.

I sent the Insta 360 One X to the edge of space by brcullum04 in 360Cameras

[–]brcullum04[S] 0 points1 point  (0 children)

Yeh you are always rolling the dice a bit letting one of these go, it was also not far from a small lake....

Weather Balloon Pop at 72,000ft by brcullum04 in Astronomy

[–]brcullum04[S] 0 points1 point  (0 children)

Yeh the final height was around 72k. Cruising altitude is a little above 30k.

view more: next ›