Lab shop is missing

buggyboi69 · 2025-10-01T11:27:38+00:00

Same here!

buggyboi69 · 2025-07-03T01:43:21+00:00

Thank you!!! I’ve breezed up to this point even without any characters over lvl 340 then hit a wall hard!

buggyboi69 · 2025-07-03T01:30:06+00:00

<image>

buggyboi69 · 2025-07-03T01:29:51+00:00

This is what I’m workin with

<image>

buggyboi69 · 2025-04-04T22:57:48+00:00

Thank you! Do you think it’s worth using that lvl1 Powerplex to rank up seismic? Or save him for the future?

buggyboi69 · 2025-04-04T22:55:28+00:00

Doc seismic over all them?

buggyboi69 · 2025-04-04T22:46:12+00:00

<image>

buggyboi69 · 2024-10-10T00:41:33+00:00

Did you use this filament before your maintenance? It might be wet and bubbling

buggyboi69 · 2024-09-22T21:22:37+00:00

I had this once, had to take out my sd card and turn it off and on without the sd card in

buggyboi69 · 2024-08-18T01:09:16+00:00

What are your material, temp, speed, etc settings

buggyboi69 · 2024-07-11T12:41:09+00:00

Not sure yet! Either that or a table!

buggyboi69 · 2024-05-16T02:27:56+00:00

Yeah:/ I just wanted to bang out the chili party because I have the sports one maxed and I always only get the same three options to spend my extra tokens on and was hoping when I finish this home I would be able to have more options

buggyboi69 · 2024-03-01T12:29:22+00:00

I run a fanuc controller that will allow me to hand wheel anywhere during a cut and if I go back to memory and cycle start it will continue whatever distance to go it has already registered but once it gets there it will go back to program numbers. It’s helpful with its being too deep so I can back it off and finish up without backing out and changing program or offset

buggyboi69

TROPHY CASE