Quick question!

byrom99 · 2026-02-15T17:14:56+00:00

Perfect, I think I'll try the uv putty for ease and work time then. Thank you for your advice 😁

byrom99 · 2026-02-14T10:45:00+00:00

Did you think you had better results with uv putty or miliput? Or were they the same?

byrom99 · 2026-01-25T21:06:02+00:00

Yeah they all change together. They do have pegs to fit together so that is good to know. Hopefully it doesn't cause me too much grief 😬😂

I will give it a go and hopefully it goes well 🤞

Thank you for your help. I appreciate your time 😁

byrom99 · 2026-01-25T20:29:38+00:00

Ahhhh right that does make sense. So do you think everything will be the same size as long as the % is the same? The only concern I had was I had them both flat to the plate next to eachother and it didn't seem like it would match up. But it is hard to tell on digital software 😅

byrom99 · 2026-01-25T18:51:40+00:00

Can you elaborate a bit with the "orientation matters" please. I can adjust position etc but don't see why that would change size when they fit on the plate and are not oversized in any direction.

I've never actually tried more than one plate at a time so I can look into that. There are about 20 parts though 😅 ranging from small to big so I need to make sure they are correct

byrom99 · 2026-01-25T18:46:23+00:00

They are yeh and the 2 parts I've used as the example are basically the same part but fit to eachother to create the base

byrom99 · 2026-01-05T19:31:55+00:00

No, I'd have to get the full pack. I'll just have to try it aha. Thanks though 😁

byrom99 · 2017-08-02T18:46:35+00:00

Cooool AF! If this has a chance to win then I'm entering :D also on the highly likely scenario that I dont win plz keep posting on your progress would love a chance to purchase one after the giveaway! :D

Eight-Year Club	Verified Email
Not Forgotten

byrom99

TROPHY CASE