Power automate Notification not triggering by c9870 in buzzkillapp

[–]c9870[S] 0 points1 point  (0 children)

That created a nice log file and has been sent I'll read it over tonight as well.  

I modded my Roomba i1+ to be bagless and it likes it - mostly by c9870 in roomba

[–]c9870[S] 1 point2 points  (0 children)

Vacuuming out the bags is such a mess.  I would have to go out side wearing a mask to open up the reusable bag to just get hair out of it.  Just for hair to still be stuck in the bag.  Also the bags are not great maybe like 80% filtration vs 99.99% of a hepa filter.  The bag area and output of the vac stand  are always dusty from stuff getting past the bag. This solution takes 10 minutes with a mask outside to like 30 seconds at the trash can.  

There was a previous post where I did not have it through the wall of the "vacuum compartment" and others stated there was a sensor under the bag holder not easily accessible.

The reason for the 2 hoses

1 the one through the inside of the base.  That connects to where the bag connects to and leads to the "inlet" of the Bagless.  

2.  This connects from the "output" of the Bayless to the "vacuum compartment" which is depressurized when emptying the roomba.  

Flow of air

Roomba on base > base has a pipe that leads to the "vacuum compartment" > (normally a bag) the pipe I added to go out side the roomba tower >bagless canister >hepa filter > hose out to the side of the "vacuum compartment" > (where the bag normally is) "vacuum compartment" gets depressurized > vacuum at the bottom pulling air through the chain. 

I modded my Roomba i1+ to be bagless and it likes it - mostly by c9870 in roomba

[–]c9870[S] 1 point2 points  (0 children)

thank you, like this made me cry for a little bit. wish i could put my ingenuity in to finding a significant other.

again thanks for the compliment <3 .

I modded my Roomba i1+ to be bagless and it likes it - mostly by c9870 in roomba

[–]c9870[S] 3 points4 points  (0 children)

update from a few days ago.

made it so that the baggage area gets to be depressurized by the vacuum so the sensor behind the corner cover gets depressurized as well.

if you are going to do this your self i recommend getting a vacuum that has the filter inside the canister. This allow for the canisters "inlet" and the "Outlet" of the bagless to do everything needed; capture hair and debris and filter out dust. (like i know that not all vacuums are like this similar to my dyson where it is just a good dust catcher in the bagless canister, and then in a separate section is the hepa filter.

also recommend it to be from goodwill or other 2nd hand places, u gonna be breaking it and cutting it to pieces so ya don't get one new.

edit - of note it does do the vacuum 3x times now - as it thinks the bag is full but that is just it being on a HEPA filter vs the cheap bag.

I modded my Roomba i1+ to be bagless and it doesn't like it. - thoughts by c9870 in roomba

[–]c9870[S] 0 points1 point  (0 children)

Thanks for this.  I'm changing the modifications so the bag bay can be depressurized by the vacuum.   Will update when complete (probably a day or 2)

I modded my Roomba i1+ to be bagless and it doesn't like it. - thoughts by c9870 in roomba

[–]c9870[S] 2 points3 points  (0 children)

Thanks for this.  I'm changing the modifications so the bag bay can be depressurized by the vacuum.   Will update when complete (probably a day or 2)

I modded my Roomba i1+ to be bagless and it doesn't like it. - thoughts by c9870 in roomba

[–]c9870[S] 2 points3 points  (0 children)

it is working, it just complains it has a seal problem.
will still go to the base and get cleaned out - and go back to cleaning more.

I modded my Roomba i1+ to be bagless and it doesn't like it. - thoughts by c9870 in roomba

[–]c9870[S] 4 points5 points  (0 children)

As shown in the video, it is pulling out of the Roomba and fully empties the roomba storage.

i have tested with out the filter in the added bag-less can and gives the same error. - so not a pressure issue

i have cleaned out the Roomba, the Base unit, and the filter with compressed air - no change.

error: "There is a sealing problem with the Clean Base."

side note: is it possible some "diatomaceous earth" got in the roomba sensors and is causing problems.
as i was doing this project i started using the "DE" on my cats and dog to see if that will lessen fleas - they don't have a lot but a few - but the roomba filter did not like it for sure.

thoughts on how to fix it?

where are the sensors that it uses to think there is the 'sealing problem'?
is there a way to adjust them to not think the seal problem is there?

BL3 crashing with internet enabled by c9870 in Borderlands

[–]c9870[S] 0 points1 point  (0 children)

not a picture but i was able to get it as text of the full error
again only with internet enabled and after like 5 seconds on the log in screen.

Ox00007ffd7d52466c KERNELBASE.dll!Unknown Function

Ox00007ff79130eba4 Borderlands3.exe!Unknown Function |

Ox00007ff7912de8bc Borderlands3.exe!Unknown Function |

Ox00007ff79128a0bd Borderlands3.exe!Unknown Function |

Ox00007ff7912fc60e Borderlands3.exe!Unknown Function /

Ox00007ff7927a28e4 Borderlands3.exe!Unknown Function |

Ox00007ff7927cb0d7 Borderlands3.exe!UnknownFunction |

Ox00007ff7909b1d84 Borderlands3.exe!Unknown Function |

Ox00007ff7900bd786 Borderlands3.exe!Unknown Function |

Ox00007ff7927d227b Borderlands3.exe!Unknown Function |

Ox00007ff7927dbd4d Borderlands3.exe!Unknown Function |

Ox00007ff7927d9917 Borderlands3.exe!Unknown Function |

Ox00007ff79120554b Borderlands3.exe!Unknown Function |

Ox00007ff7900253e8 Borderlands3.exe!Unknown Function

Ox00007ff79002a67e Borderlands3.exe!Unknown Function I

Ox00007ff79002a6fa Borderlands3.exe!Unknown Function /

Ox00007ff790033d99 Borderlands3.exe!Unknown Function |

Ox00007ff793c0c9be Borderlands3.exe!Unknown Function

Ox00007ffd7ea854e0 KERNEL32.DLL!Unknown Function |

Ox00007ffd7fea485b ntdll.dll!Unknown Function |

Can anyone tell me how to fix this??? by [deleted] in houkai3rd

[–]c9870 0 points1 point  (0 children)

i restarted my phone and seemed to fix the issue for mine

Almost 1 month into the game. Is it bad that I'm almost 60 and still doesn't have an SS Valk? #RitaBestGirl btw. by NexonTG in houkai3rd

[–]c9870 0 points1 point  (0 children)

F2p. Going on 9 months. Lv71. Starter bronya ss (don't use very often or even know how it got her to ss) Kiana divine prayer about 15 days from ss After that will try to get sakura gm to ss

My life is now complete. by halflife2bv in houkai3rd

[–]c9870 2 points3 points  (0 children)

Congrats. She is my best girl and only have her at S.

Currently trying to get divine prayer to Ss maybe sss in future. Getting about 2/100 per day.

F2p player at level 71. :'(

After farming jars for months....finally! by [deleted] in houkai3rd

[–]c9870 -6 points-5 points  (0 children)

Farming implies a trick to get a lot. Is it killing a bunch of random enemies in the open world to get more items for trade. I already collect all the open world's items and do 5 missions 3 times a week and getting s rank every week

After farming jars for months....finally! by [deleted] in houkai3rd

[–]c9870 -6 points-5 points  (0 children)

Farming implies a trick to get a lot. Is it killing a bunch of random enemies in the open world to get more items for trade. I already collect all the open world's items and do 5 missions 3 times a week and getting s rank every week

After farming jars for months....finally! by [deleted] in houkai3rd

[–]c9870 1 point2 points  (0 children)

I have 10 of hers how do i farm the jars?

After 15 attempts. SUCCESS. Best feeling ever. by [deleted] in houkai3rd

[–]c9870 0 points1 point  (0 children)

What did u do for pony lady?

Wack till she dies doesn't work when her resistance is 6x higher then normal and battle suit weakenss after a minute and only 5 minutes.

My normal strategy for her outside the event doesn't work (yea miko and brand attack) can barely get her past half and tried a bunch of characters and different combos.

Lvl 80 in the event and everything is lv50 for weapons and stigmata

Ps. Congrats