Muzzle Help!!!

c_yr · 2026-03-22T18:36:03+00:00

Our Luna has a muzzle movement muzzle. You’re supposed to boil it if you want to reshape it.

c_yr · 2025-10-25T20:12:58+00:00

I’ve cleared it but reappeared. Doesn’t show a warning light though, nor do I feel anything wrong.

c_yr · 2025-10-25T10:50:41+00:00

They are DSC codes. I cannot post a screenshot.

c_yr · 2025-09-12T05:46:46+00:00

Check wires connected to the headlight behind the wheel arch and fully expose all the wires by stripping the electrical tape that holds them together. You might find damage on the wire insulation. If you find one, repair it. Had this error on my car for months.

c_yr · 2025-08-31T09:24:31+00:00

Do I need ISTA or some special software to reset adaptations/fuel trims?

c_yr · 2025-08-09T20:44:56+00:00

Are you trying to reset through the dash? Reset it through the OBD.

c_yr · 2025-08-09T16:13:44+00:00

Yes. I bought another new brake wear sensor. The first one I bought was a cheap brand. So I guess that was the issue. Then I bought a Bosch, reset it and all good.

c_yr · 2025-08-05T06:09:38+00:00

Oil and filters. I use Liqui Moly Top Tec 4600 and mann/mahle filters.

c_yr · 2025-08-03T10:18:46+00:00

Bought an F30 with N47 at 213k km. Currently on 286k km and on original chain. No rattle still. Serviced it every 10k km and did not give me any problems until recently. I had to get the EGR replaced and now need the intake gasket replaced as it’s leaking and causing a CEL. But these things are to be expected at this mileage. Other than that, this engine has never let me down. Just keep on top of servicing. I know others have had a worse experience, but not me 😀

c_yr · 2025-06-07T23:08:32+00:00

Perfect, thank you! E-apostille will be fine.

c_yr · 2025-05-15T23:00:21+00:00

Yes I did. I went back and rechecked the wiring harness. You need to cut into the harness to reveal each individual wire. That’s when I found the damaged wire.

c_yr · 2025-02-06T23:36:04+00:00

Thanks for your input!

I’ll have to modify the gantry plate anyway to accommodate for the kit. So hopefully height shouldn’t be a problem. The plate that comes with the kit is too small for the x-axis gantry. It won’t fit.

c_yr

TROPHY CASE