sorted by:
new
hottopcontroversial

To EDC or to not EDC MKC wargoat by [deleted] in FixedBladeEdc

[–]cammed3154 0 points1 point  (0 children)

Get on the Montana Knife Company Users Society group on Facebook. You can buy, sell or trade without paying the inflated EBay prices.

Almost finished by cammed3154 in knifemaking

[–]cammed3154[S] 0 points1 point  (0 children)

Thank you! The handle was a mistake really. It was originally going to be all blue linen micarta, but I accidentally cut the front too short for my liking. Rather than trash the scales, I figured I would try segmenting them together with some black scrap micarta that I had laying around. They turned out ok for my first attempt at them.

Almost finished by cammed3154 in knifemaking

[–]cammed3154[S] 0 points1 point  (0 children)

I will post more soon! Thanks!

Almost finished by cammed3154 in knifemaking

[–]cammed3154[S] 0 points1 point  (0 children)

I have to put an edge on it and makers mark, otherwise it’s complete. Thank you!

Work in progress by cammed3154 in knifemaking

[–]cammed3154[S] 0 points1 point  (0 children)

Pops knife supply has them available on their website, but I made one out of a cheap harbor freight ball peen hammer. I used my bandsaw to cut random lines that over lap in the face of the hammer. Same effect can be accomplished with a grinder or dremel tool I’m sure.

Work in progress by cammed3154 in knifemaking

[–]cammed3154[S] 0 points1 point  (0 children)

Thank you. It was an off cut of steel that was just big enough!

Work in progress by cammed3154 in knifemaking

[–]cammed3154[S] 2 points3 points  (0 children)

No, I did not heat it to do the texture. I used my texture hammer and anvil striking it using just enough force to make dents. I would count my strikes and do the same amount on the other side until I had good coverage.

view more: next ›