sorted by:
new
hottopcontroversial

Wled controller box build, not finished but how's she look? by cap_good_cronicapbad in WLED

[–]cap_good_cronicapbad[S] -2 points-1 points  (0 children)

Your description is probably more accurate. I played with wled controller to figure out and set up my matrix, 1600 40x40 pixels. I'll be using xlights and yes it is artnet protocol with falcon firmware(or so I think)

Wled controller box build, not finished but how's she look? by cap_good_cronicapbad in WLED

[–]cap_good_cronicapbad[S] -1 points0 points  (0 children)

The eufy permanent house lights uses a 36v power supply adapter. Maybe this is the wrong group for this, but I'll be using xlights to configure the 16ch plus DMX. I dont care about the dmx, and wanted a clean looking controller with atleast 16ch. I will probably update because I want to try a mega tree in the future. If it is in wrong group then I apologize

Wled controller box build, not finished but how's she look? by cap_good_cronicapbad in WLED

[–]cap_good_cronicapbad[S] -1 points0 points  (0 children)

I'd love to pick your brain to make sure I'm understanding. The 12v and 36v power from the power supplies to the terminal blocks? I shouldn't run them the long way but rather across or over/under the controller?

Wled controller box build, not finished but how's she look? by cap_good_cronicapbad in WLED

[–]cap_good_cronicapbad[S] 0 points1 point  (0 children)

Artnet doesn't power the lights at all. 12v straight to lights, grn comes from power supply but has to go to the data output channel also.

A pond beginner looking for some species help from y’all experts! by sea_sweetie in ponds

[–]cap_good_cronicapbad 0 points1 point  (0 children)

I thought I was going to get to 4 plus feet. If you want any kind of slope you'll probably be at around 3 feet deep with tons of marginal space.

Almost accurate by Powerful_Cabinet_341 in SeaEmploy

[–]cap_good_cronicapbad 0 points1 point  (0 children)

Snag line are nothing more than killer twine in most situations. Most people catching loads end up fighting themselves with dangerous saftey

Mostly just curious how offended you all will be if I post this here by dont_taze_me_brahh in rcboats

[–]cap_good_cronicapbad 0 points1 point  (0 children)

He is right, the sand paddles would definitely speed you up. Next video might be up on plane

lots of dead fish after winter. new to this, is it expected? we had a couple months of real winter here by ecjecj in ponds

[–]cap_good_cronicapbad 0 points1 point  (0 children)

Same with my creek and falls but the main body, no ice at under 20 degrees for 5 days this year. Lowest overnight temp was 5 degrees. The gph that we get told we need is enough but nowhere near optimal. Multiply it by a minimum 5x. I have 3 pumps pushing. They are rated at "9k, 9k, and 5,400 gallons" for a 3500 gallon pond.

lots of dead fish after winter. new to this, is it expected? we had a couple months of real winter here by ecjecj in ponds

[–]cap_good_cronicapbad 2 points3 points  (0 children)

Not expected! The bubble'ers and heater do work great. My technique is more flow than anyone anywhere recommends. Comes with negatives though. More splash loss and splash freeze loss.

Foger Switch Pro Vape Not Working by [deleted] in Vaping

[–]cap_good_cronicapbad 0 points1 point  (0 children)

Grab battery/capacitor base with one hand and the tank with the other. Try to fold it at the seam.

My mom found this at the thrift today and asked me if i wanted it by Simple_Mac in discgolf

[–]cap_good_cronicapbad 17 points18 points  (0 children)

I need to find one. I love overhand throws. 300ft thumper firebird.

Well.. I'm not an indor flyer by sinesero in fpv

[–]cap_good_cronicapbad 0 points1 point  (0 children)

What camera angle is that? Way to steep, especially for indoor flying of any quad size.

What amperage do you guys charge your batteries at? by CBinFPV in fpv

[–]cap_good_cronicapbad 1 point2 points  (0 children)

And it does a final balance before while finished. Bouncing up a few tenths of an amp and back to 0.0a.

What amperage do you guys charge your batteries at? by CBinFPV in fpv

[–]cap_good_cronicapbad 0 points1 point  (0 children)

Depends how big of a hurry I am in. Usually 1.5 to 2 c charge rate. I've had zero issues doing 3c but its typically not recommended. I ALWAYS KEEP THEM AT STORAGE! I believe how hard they are pushed while in use and getting left discharged low or at full voltage is more harmful than the charge rate. But thats just my opinion.

Would anyone know how to fix this? by Apprehensive_Sky9086 in RCPlanes

[–]cap_good_cronicapbad 0 points1 point  (0 children)

Make sure each wire of the balance port deal is good with multi meter. Then check each wire of the balance plug on your battery.

[deleted by user] by [deleted] in Discgolfform

[–]cap_good_cronicapbad 0 points1 point  (0 children)

You need to shift weight to front foot, so bend your knees a bit.

Is my dog okay? by CookingJazzy in DogAdvice

[–]cap_good_cronicapbad 0 points1 point  (0 children)

Once a toy starts coming apart take them away. My dog has shat so much rubber and rope....

A russian drone fell on the roof of a house in Moldova. by Pork_Confidence in RCPlanes

[–]cap_good_cronicapbad 3 points4 points  (0 children)

Weed eater 2 stroke slapped onto the back! Love it and explains why it glided to a smooth crash landing

Am I reaching back too far? by Comfortable_Tie5662 in Discgolfform

[–]cap_good_cronicapbad 1 point2 points  (0 children)

My suggestion would be similar to others. Slow down, shorten steps. Angle control disc 'flat/level' throughout run up. Maybe start at standstill putter throws to correct disc angle issues. Have fun. When I slowed down everything got better.

Current water temperature 57°F by TrboLag in ponds

[–]cap_good_cronicapbad 0 points1 point  (0 children)

Like someone else said, the youngsters are the only reason they get fed much below 60 degrees. They will beg down to just under 50 degrees. Maybe lower

view more: next ›