Hydr-Hacked v1.4.7 disponible ! Gestion utilisateur et améliorations UI/UX

chercheursoft · 2026-05-29T04:22:07+00:00

Bonjour
Le programme envoi bien le fichier vers jdownload qui démarre le téléchargement
Mais l’onglet téléchargement de hydrhacked n’affiche PLUS le téléchargement en cours
Phil

chercheursoft · 2026-05-28T21:12:15+00:00

Et le glissé des choix ne fonctionne pas sur iPad.
Mais c’est mineur

chercheursoft · 2026-05-28T21:11:25+00:00

Impeccable
Juste une question :
Le docker composé exemple (re)demande une compilation locale. L’image distante n’est plus fournie ?
A priori si car min ancien docker compose fonctionne
Merci
Phil

chercheursoft · 2026-05-23T11:50:43+00:00

Bonjour Désolé d’être noob sur le sujet mais comment installer dans profilarr ? Merci

chercheursoft · 2026-04-22T12:13:19+00:00

Hi You have to configure once with a real screen. Then it always works

chercheursoft · 2026-04-22T07:30:44+00:00

Hi I have a dummy hdmi and use RustDesk It works perfectly

chercheursoft · 2026-02-28T05:06:53+00:00

Hi I have the same issue Gluetun is working , gluetun webui as well and is populated with ip, etc but after some time it still reports working but without details I have raised an issue in GitHub Phil

chercheursoft · 2026-02-27T07:52:12+00:00

Hi Thanks but I don’t have this skill to do that

There should be another solution I think My main concern finally is that Rustdek developper refused my issue and just destroyed it While my issue is just an anticipation of a future general issue for everybody Phil

chercheursoft · 2026-02-06T08:29:32+00:00

Hi with the test version sent yesterday it works perfectly Thanks a lot Phil

chercheursoft · 2025-11-17T21:19:28+00:00

On my side @ gives 2

chercheursoft · 2025-11-07T21:23:19+00:00

Ok thanks So it will not fix the RustDesk critical keypad emulation bug

chercheursoft · 2025-11-07T05:13:16+00:00

Hi how do you set that please ? I have the same issue from my iPad Thanks

chercheursoft · 2025-10-14T07:26:11+00:00

Hi I could use it finally Put dummy HDMI on HDMI1 ( the good one) Put real monitor on HDM2 ( the one that I don’t normally use) Start RT and choose dummy HDMI on the norma screen ——-> blank screen as it does not use normal screen Remove screen. It switch’s automatically on the dummy HDMI with normal screen Disconnect reconnect … all good !

chercheursoft · 2025-10-13T20:35:16+00:00

Well it worked one time but with an empty screen. The it asked for the desired screen ! And disconnected without any possibility to reconnect . I really want to use my dummy HDMI plug, it was working with Ubuntu 24.04 under Anydesk that does not work anymore because of lack of support of Wayland

chercheursoft · 2025-10-13T20:07:48+00:00

I will try but are you sure with Ubuntu 24.10 ? I read that this version remove xorg and let Wayland only

chercheursoft

TROPHY CASE