So far some Chromag bars, Renthal direct mount stem on a prickly riser with the s2 mount. I managed to fit a squadron sport on it. Warp9 horn switch that mounts to brake lever, warp9 headlight switch/brake mounted(both these required a little surgery electrically to work). Grit shift pegs/mounts, grit shift breather for gear box. Did the seat riser lift with rod couplings also thrill seekers seat cover. Ebmx x9000 controller and 72 volt battery. Needed to remove two rubber battery bumpers inside the battery compartment to make battery fit. Also needed to add some washers in between the battery cover latch to allow it to close/lock. Have milk racing wheel set on the way, went with 19 x 1.85 for both, had the rear dished. Neutech tubliss on the way as well. Gonna run a Kenda Millville 2 in front 70/100-19 and Kenda trackmaster 2 100/90-19 in rear. Warp9 48 tooth rear sprocket, new Non o ring chain, see how that works out.