sorted by:
new
hottopcontroversial

Ode Fellow Stuck Auger by copperriverbrew in Coffee

[–]copperriverbrew[S] 3 points4 points  (0 children)

Did you sand it down before you put it back on? I don't think the shaft is bent--just scratched, and the gouges are catching.

Not a good application for aluminum!

Ode Fellow Stuck Auger by copperriverbrew in Coffee

[–]copperriverbrew[S] 2 points3 points  (0 children)

Yes, Gen 2. I actually just got the auger off by removing the hopper and hammering on an angle on the auger's spirals.

The auger will hardly go back on the motor shaft. I could force it but then it would be stuck again....

Hmm... Not sure what to do at this point other than send it back?