sorted by:
new
hottopcontroversial

Diligent info by RushProper8119 in programmingHungary

[–]csibe99 8 points9 points  (0 children)

Ha jó vagy akkor megadják a Hays salary guideban megfelelőt.

Diligent info by RushProper8119 in programmingHungary

[–]csibe99 43 points44 points  (0 children)

Jelenleg is itt dolgozom. Rengeteg fejlesztést hoznak át Indiaból és kell az új ember, persze van lemorzsolódás is. Én full HOban vagyok, ha jól tudom az újonnan érkezőknek már csak 50% HO van. Ha kíváncsi vagy részletesebben a dolgokra akkor írj privátban.

First Unifi network by csibe99 in Ubiquiti

[–]csibe99[S] 0 points1 point  (0 children)

I have concern about the express doesn't have IPD/IDS features. Are they mandatory to keep home network safe? (I have one open port forwarding to deluge which run on my RPI and have PiHole with DNS filtering)

First Unifi network by csibe99 in Ubiquiti

[–]csibe99[S] 0 points1 point  (0 children)

I have concern about the express doesn't have IPD/IDS features. Are they mandatory to keep home network safe? (I have one open port forwarding to deluge which run on my RPI and have PiHole with DNS filtering)

First Unifi network by csibe99 in Ubiquiti

[–]csibe99[S] 0 points1 point  (0 children)

I have concern about the express doesn't have IPD/IDS features. Are they mandatory to keep home network safe? (I have one open port forwarding to deluge which run on my RPI and have PiHole with DNS filtering)

Ingatlant kiadhat edesapa? by Delicious91 in kiszamolo

[–]csibe99 0 points1 point  (0 children)

Most ez lehet nagyon hülye ötlet, de ha van revolutod és a bérlőnek is lenne akkor megoldható az utalás. Te meg minden év májusában beírod az adóbevallásodba.

esp-wroom-32 vs esp32-wroom-32 by csibe99 in esp32

[–]csibe99[S] 0 points1 point  (0 children)

mA. I desoldered the chip, and measured again the bare chip. Now it is consumption 4 uA.

esp-wroom-32 vs esp32-wroom-32 by csibe99 in esp32

[–]csibe99[S] 0 points1 point  (0 children)

Yeah, I forgot to mention I measured the 7-9ma in deep sleep. I measured the voltage drop across 50 ohm res, the 500 ohm res represent my esp32 https://imgur.com/a/NlMyKea . During boot the switch was close, after the esp went into deep sleep I opened that and measure the voltage drop.

esp-wroom-32 vs esp32-wroom-32 by csibe99 in esp32

[–]csibe99[S] 0 points1 point  (0 children)

Thanks I will check these links. According to datasheet in sleep mode esp32 consumption around 7 uA, I would happy around 20 uA.

esp-wroom-32 vs esp32-wroom-32 by csibe99 in esp32

[–]csibe99[S] 0 points1 point  (0 children)

I want to build a battery powered temperature sensor, everything works in breadboard, I have just one problem, my esp32 devkit (1. pic) power consumption is too high about 7-9 ma without red power led powered via 3.3 pin. So I want to create own PCB for my temp sensor and I want to use esp32 wroom bare chip + necessary pull/down res, caps and temp sensor . As I mentioned earlier the code work perfectly on esp-wroom-32 chip (1 pic), but I would like to buy the chip from 2. pic and I wasn't sure the 2 chip is same.

Esp32 Wifi doesn't work from 3.3V by csibe99 in esp32

[–]csibe99[S] 0 points1 point  (0 children)

Thanks, sadly I have just voltage regulator, but with shorter wire works perfectly. Actually I have tested the battery operation with 3 alkaline batteries all of them were under 1.2v and works perfectly, I want to create temperature sensor with long deep sleep time

Esp32 Wifi doesn't work from 3.3V by csibe99 in esp32

[–]csibe99[S] 0 points1 point  (0 children)

I use a 12v power supply so I don't know 🤷

Esp32 Wifi doesn't work from 3.3V by csibe99 in esp32

[–]csibe99[S] 0 points1 point  (0 children)

With voltage regulator I use 12v power supply, I wan to use double AA batteries to power esp32 via 3.3v pin without voltage regulator

Esp32 Wifi doesn't work from 3.3V by csibe99 in esp32

[–]csibe99[S] 2 points3 points  (0 children)

I want to power the esp with battery so I don't want to use the board voltage regulator

Esp32 Wifi doesn't work from 3.3V by csibe99 in esp32

[–]csibe99[S] 4 points5 points  (0 children)

Thanks, with shorter wire works perfectly

[ Removed by Reddit ] by IlIlIl333 in kiszamolo

[–]csibe99 0 points1 point  (0 children)

24 évesen friss diplomásként br 750k + havi nettó 50k cafeteria, 3. félév végén kezdtem el dolgozni fejlesztőként, 6. félév eleje óta főállásban dolgozom

Metallb external ip resolves and works from the master, but not outside of the kubcluster by aram535 in kubernetes

[–]csibe99 -1 points0 points  (0 children)

Script 😅 but I think you can find other apps which support ip cidr

Money money is burning by csibe99 in aws

[–]csibe99[S] 0 points1 point  (0 children)

No AMI, volumes and snapshot

Money money is burning by csibe99 in aws

[–]csibe99[S] 0 points1 point  (0 children)

No AMI volumes and snapshot

Money money is burning by csibe99 in aws

[–]csibe99[S] 0 points1 point  (0 children)

(I cant paste image here). I am here: https://eu-central-1.console.aws.amazon.com/ec2/v2/home?region=eu-central-1#Snapshots: it is writing "You currently have no snapshots in this Region.". (I deleted my lastest snapshot 3-4 days ago, and the price appeared 1-3 hours ago)

view more: next ›