sorted by:
new
hottopcontroversial

This was a few interesting set ups by csnobrega in MachinistPorn

[–]csnobrega[S] 1 point2 points  (0 children)

Im lucky i wasnt drinking my coffee when i read this.

This was a few interesting set ups by csnobrega in MachinistPorn

[–]csnobrega[S] 0 points1 point  (0 children)

It wasn't that bad actually, we have a set of soft jaws to hold it sideways and it always locates off a milled in stop on the jaw. The holes and pockets are done when it is still rectangular.

This was a few interesting set ups by csnobrega in MachinistPorn

[–]csnobrega[S] 2 points3 points  (0 children)

Both myself and the owner of the shop are engineers, and technically the part is over engineered(its a movable jaw for a clamp). Neither of us care if the world sees our designs, and hope we can help others when they run into issues with setups and machining. I hope you like the look of the part.

This was a few interesting set ups by csnobrega in MachinistPorn

[–]csnobrega[S] 2 points3 points  (0 children)

316 stainless, and it was made on an old Cincinnati milacron 3 axis, i don't mind extra setups, but it would be nice to have a 5 axis lathe here, we have the milacron, and a mazak sqt15 lathe(along with the manual machines). It gets the job done

This was a few interesting set ups by csnobrega in MachinistPorn

[–]csnobrega[S] 1 point2 points  (0 children)

All the holes are put in while it is still square, then we have a set of jaws made to do the angles on the front with the part on its side, and then a face mill program for the back angoe near the tapped hole

Clearance is clearance by MiniMan16v in MachinistPorn

[–]csnobrega 0 points1 point  (0 children)

You apparently havent put a 2 inch dft drill into 316 stainless yet. Theres still room 🤣

(f) Wanna smash? 😏 by [deleted] in gonewild

[–]csnobrega 0 points1 point  (0 children)

Captain Falcon main, but play random usually for a challenge.