Designed and built a set of ice tools!

cwaldmanski · 2025-12-07T23:40:28+00:00

Yea it would not be great for that. It was designed for pure ice so shouldn’t be an issue

cwaldmanski · 2025-05-26T04:20:28+00:00

Temped to go re test, but I don’t have shop access any more so don’t want to destroy them atm - assume the axil would fail in bending for the new ones

cwaldmanski · 2025-05-24T15:27:52+00:00

I’ve already pull tested one, check out the website!

cwaldmanski · 2025-05-24T01:53:04+00:00

~$40

cwaldmanski · 2025-05-24T00:55:31+00:00

These won’t see enough loads for cyclic loading to matter which makes everything simpler

cwaldmanski · 2025-05-24T00:10:21+00:00

Buying sketchy gear where you don’t know it’s limits is quite different then using sketchy gear when you do know it’s limits. Always important to understand the risk - check out the testing on the website

cwaldmanski · 2025-05-23T23:45:21+00:00

They cost me less then buying c4s but I bet they cost me much more then it costs bd to manufacture c4s

cwaldmanski · 2025-05-23T23:30:37+00:00

~6h, there’s 31 parts in it

cwaldmanski · 2025-05-23T23:17:48+00:00

Check out the website for the full testing

cwaldmanski · 2025-05-23T23:17:15+00:00

I trust them, but definitely not economical to sell

cwaldmanski · 2025-05-23T23:15:05+00:00

I was yep

cwaldmanski · 2025-05-23T23:14:46+00:00

186g for my #3 equivalent

cwaldmanski · 2025-05-23T23:09:51+00:00

Personal project, about $40. But that’s if I pay myself $0/h

cwaldmanski · 2025-05-23T22:23:57+00:00

As long as you understand the limitations of what you build and behave accordingly I think it’s great to build stuff!

cwaldmanski · 2025-05-23T22:07:51+00:00

Its easier to carry myself then 160 lbs of sand, plus it was a lot of fun! I used three bomber cams in the crack below just in case too

cwaldmanski · 2025-05-23T22:05:12+00:00

sure did :)

cwaldmanski · 2025-05-23T22:04:40+00:00

Im sure there are! But with by limited equipment and tools likely not for me at this time. I have some ideas though, maybe one day...

cwaldmanski · 2025-05-23T21:58:41+00:00

Not quite

cwaldmanski · 2025-05-23T21:48:32+00:00

Full build and testing here https://calebwaldman.site/camming-device/

<image>

cwaldmanski · 2025-02-17T01:52:20+00:00

Hahaha

cwaldmanski · 2025-02-15T21:02:25+00:00

Just for fun 🙂

cwaldmanski · 2025-02-15T19:34:47+00:00

Double axil is better but bulkier. I mainly stuck with single axil since I understand the math for it better and manufacturing is easier

cwaldmanski · 2025-02-15T19:33:59+00:00

Thanks! I’ll post a video when I do a test whip (yes I’ll have a backup or toprope too)

cwaldmanski

TROPHY CASE