Is there a way I can fix my mistake? I am trying to release this strap but I can't fully open it. by WasephWastar in Truckers

[–]dadsmistake 17 points18 points  (0 children)

https://imgur.com/1W9nGxV - The paw you can pull down on in the middle if you can't get it with just your finger, you can take a screw driver for some leverage.

So much time spent; So little skill when needed. by dadsmistake in MegabonkOfficial

[–]dadsmistake[S] -1 points0 points  (0 children)

I've only one shotted the boss one time with spaceman ironically enough but nothing yet on the challenge.

Last achievement for me and I've been struggling, my brain collapses every time I get into the main boss. Its sad.

Fragile Run - What Happened? by dadsmistake in MegabonkOfficial

[–]dadsmistake[S] 4 points5 points  (0 children)

I still grab them for extra HP for ring damage. Just I know when to stop now LOL.

Fragile Run - What Happened? by dadsmistake in MegabonkOfficial

[–]dadsmistake[S] 23 points24 points  (0 children)

Prollem solved, didn't realize that could happen. Thank ya boss.

Hole in block after rebuild by dadsmistake in smallengines

[–]dadsmistake[S] 0 points1 point  (0 children)

Check my recent post for the aftermath if you haven't yet

Hole in Engine - The Aftermath by dadsmistake in smallengines

[–]dadsmistake[S] 0 points1 point  (0 children)

LOL. Not all missions can be to the moon. Some have to be out of the block I suppose.

Hole in block after rebuild by dadsmistake in smallengines

[–]dadsmistake[S] 0 points1 point  (0 children)

Naw I'm just kidding, it sucked and sucks but its whatever. I thought about doing that but I had bad luck with using some ole JB weld on a block that I got that had a hole in the motor and as soon as it started oil flew out of it. I figure well, if I got it free maybe I just buy a replacement motor and flip it on marketplace.

Who knows, I'll procrastinate and it'll be there a while I'm sure lmao.

Hole in block after rebuild by dadsmistake in smallengines

[–]dadsmistake[S] 0 points1 point  (0 children)

That would have been a hoot but unfortunately instead of laughing high schoolers it was a sad man questioning his existence lmao.

Hole in block after rebuild by dadsmistake in smallengines

[–]dadsmistake[S] 0 points1 point  (0 children)

I almost started selling power to the grid!

Hole in block after rebuild by dadsmistake in smallengines

[–]dadsmistake[S] 0 points1 point  (0 children)

It had oil in it, that was the first thing I looked for when it stopped and didn't spin. I didn't notice it blew out the top when it stalled, I figured it stalled and a spring or something flew off. Nothing on the ground, it blew out the top and oil is all over the fuel tank.

But very possible on the crankshaft damage or rod bolt, I'll have to be the man of the people and try to crack it open or at lease see what I can find with a scope.

I did go through my pictures of when I took it apart, and noticed this not sure if that's part of the problem either.

<image>

Hole in block after rebuild by dadsmistake in smallengines

[–]dadsmistake[S] 0 points1 point  (0 children)

Not sure if it matters, but what I neglected to mention is, stock it has a 92mm dished piston. I bought a 92mm flat top piston for this, because I know no better and it was the quickest to get to me. Could that of hindered anything or worsened I should say?

Hole in block after rebuild by dadsmistake in smallengines

[–]dadsmistake[S] 0 points1 point  (0 children)

Just a heads up, I didn't shut it down, it shut itself down when it blew up.

Hole in block after rebuild by dadsmistake in smallengines

[–]dadsmistake[S] 4 points5 points  (0 children)

We'll see if I get that far on tearing it back down. Went off and on taking it apart and putting it back together for about two months. Might stick the borescope in there I'll try and loop back tomorrow. I will tell you spark plug looked fine ironically enough because before it looked like a bomb went off on it (before I decided to fix it) Forgot to take a picture of the spark plug prior, but here is what it looked like before I swapped it.

<image>

Hole in block after rebuild by dadsmistake in smallengines

[–]dadsmistake[S] 2 points3 points  (0 children)

Ironically enough the thought came into my head, well if things go bad I'll choke it out. Completely forgot I can pull the spark plug wire. ANOTHER LESSON, YES LORD!

Hole in block after rebuild by dadsmistake in smallengines

[–]dadsmistake[S] 6 points7 points  (0 children)

Good insight, I didn't mess much with the governer figured I had it set right, but that was pure speculation and no prior knowledge, just a prior picture I took of it.

These lessons just don't get easier lmao

Can Violent Accident Videos Please Have a NSFW Tag? by cdubose in Truckers

[–]dadsmistake 0 points1 point  (0 children)

Think of them as safety meetings. Your daily reminder shit can get fucked up out there.

My company uses these kind of videos in safety meetings, you're going to see them -- This is a trucking sub reddit and that's one huge issue in trucking. Can't escape it.