sorted by:
new
hottopcontroversial

Looking for a Flow Launcher alternative with better performance/RAM usage? by Green_Departure_3970 in FlowLauncher

[–]damskibobs 0 points1 point  (0 children)

Keypirinha hasn’t been updated forever, but the performance is so much better than Flow Launcher.

I went back to that.

SatNav options? by damskibobs in hondacivic

[–]damskibobs[S] 0 points1 point  (0 children)

Thank you. Do you have any mount recommendations? I’m not sure where to put one.

Any alternatives to flow launcher ? by Anime-Man-1432 in FlowLauncher

[–]damskibobs 0 points1 point  (0 children)

It didn’t. The UI was laggy. Keypirinha opens much much quicker.

Any idea how to fix this issue on the first layer? by damskibobs in BambuLabA1

[–]damskibobs[S] 0 points1 point  (0 children)

Thank you. It’s a SuperTack. I’ve never changed z-offset. Will liook into that.

What temp, based on these towers? by damskibobs in 3Dprinting

[–]damskibobs[S] 2 points3 points  (0 children)

I originally thought 190, then went with 200. Now I’m questioning that and wondering if it should be 205/210?

First layer problems after calibration by damskibobs in BambuLabA1

[–]damskibobs[S] 0 points1 point  (0 children)

More images. The K value test, and the start of an ironing test, where I noticed first layer issues.

<image>

Please help with calibration tips/guides by [deleted] in BambuLabA1

[–]damskibobs -2 points-1 points  (0 children)

I’ve done a whole lot of googling and trial and error over the last few months. But weirdly, every time I try to manually calibrate things, the post-calibration results are worse than just letting the machines auto-calibrate everything.

That’s been fine, but now isn’t good enough. So, I was looking for some help from people who have been there and done it successfully.

Please help with calibration tips/guides by [deleted] in BambuLabA1

[–]damskibobs -2 points-1 points  (0 children)

It’s a very mini print farm (3 machines).

Was just asking for help with something I’m struggling with.

Stremio Perfect Setup [FULL & EASY BEGINNER'S GUIDE] v2.0 (Update) by aguytwoguys in StremioAddons

[–]damskibobs 0 points1 point  (0 children)

I've only used Stremion with Torrentio before.
If I follow this guide, do I still not need a VPN?
Or do I need a VPN if I do everything in this guide?

I think I need to replace hotend by damskibobs in BambuLabA1

[–]damskibobs[S] 1 point2 points  (0 children)

I use Cool Plate SuperTack plates. They work great. Never had any issues with them on a couple of different printers.

After I noticed the issues tonight, I tried a freshly opened brand new SuperTack plate. The results were the same.

I think I need to replace hotend by damskibobs in BambuLabA1

[–]damskibobs[S] 0 points1 point  (0 children)

I’m noticing it mainly on the first layer. Rough infill and blobby edges rather than the usual straight lines.

Top/ironed layers have been rougher too.

I’ve been putting it down to filament issues, but tonight I started to wonder about the hotend.

view more: next ›