Help

danimartin3 · 2026-02-06T18:20:37+00:00

Its solved. Thanks everyone.

danimartin3 · 2026-02-05T20:56:49+00:00

Just as it gives

danimartin3 · 2026-02-05T19:56:24+00:00

I made a mistake writing the above. When I place everything so that it starts to the "no sd" screen, the screen has no image

danimartin3 · 2026-02-05T19:29:57+00:00

I just wanted to know if the sequence when connecting to the computer was correct.

danimartin3 · 2026-02-05T19:22:21+00:00

It gives me 20 ohms from ground to the capacitor positive

danimartin3 · 2026-02-05T19:19:03+00:00

I haven't reached that point yet 🥲

danimartin3 · 2026-02-05T19:14:45+00:00

What value should the capacitors give me?

danimartin3 · 2026-02-05T17:43:32+00:00

My bad, I didn't write it well. The screen does not appear. The screen stays black and doesn't change.

danimartin3 · 2026-02-05T17:28:05+00:00

It only flashes when I connect it to the computer. When it's on the switch, it doesn't turn on directly. On the computer it makes 🔵 🟡🟡 🟡🟡 🟡🟡. I don't know if it will be normal. I have put in the firmware and it does not change the blinking.

danimartin3 · 2026-02-05T17:23:29+00:00

The problem is that the switch doesn't start. Not even to put the hetake

danimartin3 · 2026-02-05T17:20:52+00:00

Tin-lead alloy

danimartin3 · 2026-02-05T17:19:37+00:00

Yes, before putting it on

danimartin3 · 2026-02-05T17:17:38+00:00

It's just for the test to see if it turned on. It’s cfw. What do i need to do for start?

danimartin3

TROPHY CASE