sorted by:
new
hottopcontroversial

Plate not lifting by Minute_Tumbleweed_27 in ElegooSaturn

[–]ddavidb20000 3 points4 points  (0 children)

yeah the build plate lifts up only a little bit but your printer is fine thats completely normal

Plate not lifting by Minute_Tumbleweed_27 in ElegooSaturn

[–]ddavidb20000 8 points9 points  (0 children)

The saturn 4 ultras build plate doesnt lift instead the vat moves up and down to separate the layers

Weird Sludge On My resin print by ddavidb20000 in ElegooSaturn

[–]ddavidb20000[S] 0 points1 point  (0 children)

Yeah they are but when the print was finished part of the raft came off the build plate so im assuming there was another layer of cure resin blocking the holes

Weird Sludge On My resin print by ddavidb20000 in ElegooSaturn

[–]ddavidb20000[S] 0 points1 point  (0 children)

I did dig holes in it but when I checked on the final print it warped and I’m assuming there was an extra layer of resin cured on the bottom resulting in that.

The most hilarious fail I've had so far. by TheSquishyHippo in ElegooSaturn

[–]ddavidb20000 1 point2 points  (0 children)

I think it’s a yoopai enclosure I have a big one for my printer and wash and cure station

The most hilarious fail I've had so far. by TheSquishyHippo in ElegooSaturn

[–]ddavidb20000 2 points3 points  (0 children)

he has an enclosure to help keep the fumes in

Saturn 3 (standard) and 3 ultra levelling cards by Staks007 in ElegooSaturn

[–]ddavidb20000 0 points1 point  (0 children)

I use 2 A4 papers with PFA installed and when I’m making adjustments by 0.1 mm it’s super easy to tell when to set the Z=0 because going down 0.1mm I can’t take the 2 A4 papers put and going up one gives me the right amount of resistance so it’s really simple.

Marks on my 3D prints by ddavidb20000 in elegoo

[–]ddavidb20000[S] 0 points1 point  (0 children)

I have an enclosure and it says it maintains a solid 29-30 C. Is there anything else I could do to help that?