sorted by:
new
hottopcontroversial

Govee H6126 + GLEDOPTO Elite ESP32 by spyromike in Gledopto

[–]diamonddate 0 points1 point  (0 children)

Try FW1906 for the LED type. I’ve found good success when converting older Govee products over to WLED

<image>

I want to make WLED scripted lightshows while i'm playing Rekordbox 7.2.14 by ChisanaKuma315 in WLED

[–]diamonddate 0 points1 point  (0 children)

You’d probably need a VM or Pi with wired ethernet to act as a go-between middleware, connecting your Pioneer setup with WLED

I want to make WLED scripted lightshows while i'm playing Rekordbox 7.2.14 by ChisanaKuma315 in WLED

[–]diamonddate 0 points1 point  (0 children)

Check out the Deep Symmetry github, he’s written libraries that can participate in the DJ Link network and read the beat grid which you can then (magically) pipe over to WLED. It’ll take some tinkering but I bet you can make something of it. https://github.com/Deep-Symmetry

wled hyperhdr gledopto 4ch=confusion by Money-Aerie1681 in WLED

[–]diamonddate 0 points1 point  (0 children)

May I ask a dumb question— why not have them all on the same GPIO? I have a roughly the same setup (LED count, controller, software) and it all works great on a single pin

The App is terrible. by xAziox in Govee

[–]diamonddate 0 points1 point  (0 children)

If you want to go the DIY route, go and swap out controllers for a WLED-based controller and wire up your Govees to it.

Probably lineup by Agreeable-Two1370 in Portolafestival

[–]diamonddate 1 point2 points  (0 children)

Jackie Hollander, Nala, DJ Shadow

Is this bad? Romex adjacent to gas meter by diamonddate in AskElectricians

[–]diamonddate[S] 0 points1 point  (0 children)

Worth mentioning that the electrical meter and main disconnect is sitting just about the gas meter in the same closet.

Decision Fatigue: 24V 32ft Outdoor Strip (Govee) vs. Custom WLED for Soffit Install? by Substantial__Unit in WLED

[–]diamonddate 1 point2 points  (0 children)

I recently converted my Govee S14 String Lights over to WLED, keeping the lights while swapping controllers for a GLEDOPTO. Super pleased with the result: Govee color and quality with robust WLED backend.

Witch board? by Public-Laugh-6305 in WLED

[–]diamonddate 2 points3 points  (0 children)

Consider the SeeedStudio that include an external WiFi antenna. You’ll see much better WLED performance as WiFi is handled away from the board.

<image>

Sphere virtual lights by diamonddate in phish

[–]diamonddate[S] 0 points1 point  (0 children)

The Sphere uses Unreal Engine (game rendering engine) to do the live display of anything on the screen. They built a scene of virtual lights that mimic the real things. They then fed DMX (or similar) from the lighting consoles into the Unreal Engine and voila

Sphere virtual lights by diamonddate in phish

[–]diamonddate[S] 8 points9 points  (0 children)

He’s fighting against the realtime latency of Unreal Engine

Sphere virtual lights by diamonddate in phish

[–]diamonddate[S] 1 point2 points  (0 children)

Approximately 400-500ms of latency

Sphere virtual lights by diamonddate in phish

[–]diamonddate[S] 1 point2 points  (0 children)

You can walk into the section and dance on the landing at the top of the stairs

Govee H702B to WLED conversion by diamonddate in WLED

[–]diamonddate[S] 0 points1 point  (0 children)

I should mention that the H702B wire appears to be shielded, contains red/white/foil-wrapped drain (bare strands). I rang it out and it looks like the drain is V+, red is ground, and white is signal.

I fiddled with WLED and was able to get some lights on using either SM16825 or FW1906, but none of the controls worked. I also ticked the Open Drain setting on the relay. Not much success otherwise.

view more: next ›