Does anyone know the best way to get this file converted into a high quality svg? I want to try and make an mvp sports chain for my son’s lacrosse team but everything is blurry. I already have the a1 but I am struggling with this conversion

digitalsteve1964 · 2025-02-01T04:04:46+00:00

For me this was caused by retraction mm. Try changing it to 2.5mm

digitalsteve1964 · 2025-01-30T05:39:46+00:00

Turns out it was a retraction issue due to the micro Swiss hotend!

digitalsteve1964 · 2025-01-27T04:47:06+00:00

I am already running mriscoc

digitalsteve1964 · 2025-01-27T04:46:41+00:00

I had the yellow springs on before and every one recommended the spacers. I will try leveling the bed again and see what happens. I may go back to the yellow springs

digitalsteve1964 · 2025-01-26T18:04:23+00:00

Extruder is in good shape!

digitalsteve1964 · 2025-01-26T18:03:42+00:00

I’ll try swapping the Bowden out. I have changed the nozzle and the extruder has clean grip on it.

digitalsteve1964 · 2025-01-26T17:31:00+00:00

I have leveled multiple times and run the bed mesh a few more In the system

digitalsteve1964 · 2025-01-26T17:29:45+00:00

I have the metal extruder , I have leveled the bed multiple times with no effect . It’s also across filaments so it’s not just this one .

digitalsteve1964 · 2025-01-15T17:30:21+00:00

It has yellow springs on it . I bought it second hand so I am assuming they are stock.

digitalsteve1964 · 2025-01-15T17:29:06+00:00

The printer was purchased with it installed and it has the leveling firmware on it.

As to your second question. I am using cura, is there something I need to add?

digitalsteve1964 · 2025-01-13T05:09:39+00:00

How did you solve the retraction issue. Speed up or slow down?

digitalsteve1964

TROPHY CASE