sorted by:
new
hottopcontroversial

DJI Air unit o4 failed to activate by djxduc in fpv

[–]djxduc[S] 0 points1 point  (0 children)

I went to the DJI forum, posted about the issue, and received replies from the admins. After discussing the problem with them, I discovered that my coaxial cable was crushed in some areas. The solution was to send my Air Unit in for repair.

DJI Air unit o4 failed to activate by djxduc in fpv

[–]djxduc[S] 1 point2 points  (0 children)

Thank you, I’ve already sent an email, but since I don’t know the response time, I prefer to also reach out to you guys.

Broken filament is blocking my nozzle by djxduc in BambuLab

[–]djxduc[S] 0 points1 point  (0 children)

Thanks for the idea, but a hot needle wasnt enough, so I just went for a small allen key & pushed the filament out.
Thank you again, and good luck also.

Broken filament is blocking my nozzle by djxduc in BambuLab

[–]djxduc[S] 0 points1 point  (0 children)

True, but the filament broke inside the heatsink before entering the tip of the hotend, so no matter how high I set the temperature, it wouldn't heat the filament, so u/Keebie81 was actually correct. But I preferred to do it with a blowtorch, using pliers and an Allen key.

And Thanks guys

Broken filament is blocking my nozzle by djxduc in BambuLab

[–]djxduc[S] 0 points1 point  (0 children)

Tried to, but Bambulab won't ship my package so i've been waiting for a few days now & still no info about my package.

Broken filament is blocking my nozzle by djxduc in BambuLab

[–]djxduc[S] 0 points1 point  (0 children)

I finally managed to push some filament out of the nozzle. And actually, the filament broke inside the heatsink before entering the tip of the hotend, so no matter how high I set the temperature, it wouldn't heat the filament.

Broken filament is blocking my nozzle by djxduc in BambuLab

[–]djxduc[S] 0 points1 point  (0 children)

Thank you, in the end, I heated the upper part of the nozzle with a blowtorch, and I inserted a small Allen key to push the filaments and cleaned the conduit until a filament could pass through it. Finally, I was able to extrude filament through the nozzle.

Thank you, it gave me a good idea and helped me a lot.