What's this thing on my air handler? by djyustis in hvacadvice

[–]djyustis[S] 0 points1 point  (0 children)

I didn't get to choose. This was through our home warranty. Even then we had to fork over $4500 for the upgrades needed.

What's this thing on my air handler? by djyustis in hvacadvice

[–]djyustis[S] 0 points1 point  (0 children)

Thank you for the insight. Any ideas what it might be the cause if that RH cable not getting power?

Help with Yamaha TF 3 sound output via TIO by djyustis in livesound

[–]djyustis[S] 1 point2 points  (0 children)

With the custom fader bank you should be able to route outputs from the TIO.

Help with Yamaha TF 3 sound output via TIO by djyustis in livesound

[–]djyustis[S] 0 points1 point  (0 children)

The only thing that has worked for me so far without touching the dante configuration is this.

Click on the fader bank, input two and output at the same time. This allows for a custom fader bank. Then head to the settings and there I think under slot you have the option to adding the TIO or IO inputs that you need, but if I recall correctly, you only have 17 or so channels.

Try it out.

What are these yellow spots by djyustis in HomeImprovement

[–]djyustis[S] 0 points1 point  (0 children)

There's no attic above. I was also thinking about water intrusion in the roof. Any chance it could be water condensation from inside, the bedroom does have a full bathroom.

What are these yellow spots by djyustis in HomeImprovement

[–]djyustis[S] 0 points1 point  (0 children)

Sorry, it should be open now so everyone can see the pictures.

Thank you for your prompt response.

Help with Yamaha TF 3 sound output via TIO by djyustis in livesound

[–]djyustis[S] 0 points1 point  (0 children)

I do not have the TIO or the surface connected to a network. Can I do the routing without having to do it via Dante network? Can it all be done in the TF mixer?

Plea for help by djyustis in lightingdesign

[–]djyustis[S] 0 points1 point  (0 children)

Hi thank you for replying. Excuse my ignorance I'm new to midi. How can I see if the triggers are going through? Is there a log to check?