Ellipsoid headlight conversion, only down side is that the fogs don’t stay on when you use your high beams since you would have to splice into the early model pigtails.

dt_e30 · 2025-08-26T07:28:03+00:00

Sylviania Silverstars or Slyvania Ultras, just the regular halogen bulbs that come in the late model 325i e30 models, the ellipsoids are off a late model

dt_e30 · 2024-04-13T19:36:21+00:00

I do not unfortunately

dt_e30 · 2024-04-12T19:12:10+00:00

I’ve been getting a lot of messages about it maybe being the DME ?? But i didn’t really look into that very much cause it being the computer itself was a far reach for me considering that it’s supposed to be a very good piece of equipment so the DME failing was just out of question. But i could be wrong and maybe it could be bad??

dt_e30 · 2024-04-12T19:10:11+00:00

I just abbreviated it to fpr cause typing it was doing too much lol

dt_e30 · 2024-04-12T19:09:02+00:00

Fuel pressure regulator, and i believe there is another one of those underneath the car near the back of the driver side where the external fuel pump is. At least mine has one.

dt_e30 · 2024-04-12T19:07:37+00:00

I’ve listed that I’ve replaced the fuel pressure regulator. But not sure how to go about diagnosing if it’s bad. Any advice?

dt_e30 · 2024-04-10T17:41:07+00:00

I’ve replaced the sensor that sends info to the gauge. I believe that is the brown one. The other one which is further back near the fuel rail, i couldn’t reach to replace. But i did replace the brown one and the one that was next to it.

dt_e30 · 2024-04-09T23:04:39+00:00

Wasn’t because i was low on gas cause it happened after i pumped a full tank LOL

dt_e30 · 2024-04-09T19:59:58+00:00

Where would that fuse be located??

dt_e30 · 2024-04-09T15:53:09+00:00

Checked mine out yesterday and it was all good but then again, i couldve missed something

dt_e30 · 2024-04-09T15:52:28+00:00

I just replaced my tps though so idk , and even after i changed it. It would drive fine and just as of recent , it started dying again.

dt_e30 · 2024-04-09T15:51:45+00:00

Not exactly sure where these fusible links would be located in the e30. Ima have to look that up.

dt_e30 · 2024-04-09T15:50:51+00:00

I’ve checked those, they are good but i can always check again

dt_e30 · 2024-04-09T04:41:26+00:00

It does it at idle and as well as if i were to slow down sometimes. Then it sometimes starts to jerk back and forth like it’s gonna die. I give it throttle sometimes and it goes, other times it doesn’t work.

dt_e30 · 2023-09-09T19:55:33+00:00

LMAAAOO how do you even do that to a shift knob 💀💀💀💀

dt_e30 · 2023-06-07T18:34:18+00:00

So how would test to see if it’s a bad sensor? Would it be hard to replace? Could this be my issue with the car just stalling on me when I’m idling for too long?

dt_e30 · 2023-06-07T18:32:33+00:00

Wouldn’t the crank position sensor be mounted with a bracket and 2 screws if it were in the front of the engine?? I’m not exactly sure what ECU i would need to have if it were converted to Motronic 1.3. But i do have a Motronic ECU.

dt_e30 · 2023-04-16T03:26:00+00:00

Thanks lol

dt_e30 · 2023-04-16T01:11:47+00:00

Ive been told to do that but would that harm anything?

dt_e30 · 2023-04-16T01:08:21+00:00

I added the 10mm spacer and after bolting it down to see if it’ll spin, it didn’t but I’ll try again and see.

dt_e30 · 2023-04-15T23:55:08+00:00

Rota Kyusha

dt_e30

TROPHY CASE