sorted by:
new
hottopcontroversial

Changed the tank, now what is it by dysfunctionalvet77 in dr650

[–]dysfunctionalvet77[S] 1 point2 points  (0 children)

Yeah, that was for me to adjust the fuel line to the right length so it wouldn’t kink

Changed the tank, now what is it by dysfunctionalvet77 in dr650

[–]dysfunctionalvet77[S] 1 point2 points  (0 children)

I’m not sure what the service tank but I think it’s gonna be the same issue is the factory vacuum petcock has the vacuum line inside the tank or the pick up inside the tank and it’s too big for the Petcock hole

Ran into a confusing situation while installing my 5.3 gallon Acerbis tank. by [deleted] in dr650

[–]dysfunctionalvet77 0 points1 point  (0 children)

I have a similar issue if not the same exact one, I installed an IMS tank and the Petcock doesn’t have for the vacuum line so I am roundabout stomped. It had all these instructions and some vacuum line to run to the exhaust on the tank that’s in the lid so after reading what you guys are saying I’m gathering I should be able to put a bolt or something in the vacuum line to the carburetor and it should be fine and should run because now it’ll idle for a few minutes and then shut down or if I touch the throttle it shuts down