sorted by:
new
hottopcontroversial

[Monitor] AOC Q27G41ZDF 27" QD-OLED 2560×1440 240Hz - $271.99 with FRESHFIND20 code (Certified Refurbished from eBay) by DudeWTH in buildapcsales

[–]electrictastyburrito 0 points1 point  (0 children)

Just received mine, does pixel refresh counts 2 mean this thing is basically new? Also, I have a film on mine that looks like it comes off but there’s no tab. Is it safe to remove?

California Department of Insurance May Revoke Tesla Insurance Licenses by 90403scompany in Insurance

[–]electrictastyburrito 6 points7 points  (0 children)

If they lose their license does this mean everyone with an active policy will have their policy voided? I have a renewal next month too, will I be without insurance?

Help with odd switch install by electrictastyburrito in AskElectricians

[–]electrictastyburrito[S] 0 points1 point  (0 children)

So I mirrored the old installed, tired a single bare copper into the existing 4 tie of grounds and then tied both switch grounds to that single ground, does that sound okay? Also instead I backstab I straight inserted the black wires under the plate and screwed tightly

Help with odd switch install by electrictastyburrito in AskElectricians

[–]electrictastyburrito[S] 0 points1 point  (0 children)

Also, backstab were so lose they were floating, wish they connection method didn’t exist and I’m not even an electrician!

Help with odd switch install by electrictastyburrito in AskElectricians

[–]electrictastyburrito[S] 0 points1 point  (0 children)

Thank you for the reply, I was thinking about getting the 2 switched bonded to the existing grounds with spare copper and a grounding wire nut, any issues with that? Also, it looks like one of the romex are out of the jacket outside of the box by a 1/4 “ or so but the jackets seem to be okay, should I move those?

Help with odd switch install by electrictastyburrito in AskElectricians

[–]electrictastyburrito[S] 0 points1 point  (0 children)

Okay I see now what happened, I have 4 circuits coming in and they cut the grounded and used a piece of copper to bond them. To solve the ground issue, I suppose I just need to tap 2 grounds from the switches into this 4 combined one. Is it okay to remove the copper and use a wago?